The main results are: (1) For a dual-rate sampled system, the design methods of predictive controller based on state-space model and input-output model are given respectively.
论文的主要结果有(1)对双速率采样系统，分别给出了基于状态空间模型和输入输出模型下的预测控制器的设计方法。
The input signal is sampled on the falling edge of CS and the conversion is also initiated at this point.
输入信号在CS的下降沿进行采样，而转换同时在此处启动。
Sampled channel is related to the linearity of input voltage and output voltage, so the design of this channel is also involved in this thesis.
采样通道关系到采样输出电压与采样输入电压的线性度，因此通道的设计在本文中也有涉及。
The differential input is sampled at up to 40 MSPS by an analog modulator.
差分输入由模拟调制器以最高40MSPS的采样速率进行采样。
A stable adaptive control approach using dynamic neural networks has been developed for a class of multi input multi output MIMO sampled data nonlinear systems with unknown dynamic nonlinearities.
研究了一类采样数据非线性系统的动态神经网络稳定自适应控制方法。
Based on the sampled date of the system input and output, the paper presents a method for numerically analysing the system model order.
根据对象的输入输出采样数据，用数值计算方法分析热工对象模型的阶次。
The sampled output represents the analog value corresponding to the input digital word.
采样输出表示与输入数字字相对 应的模拟值。
This ensures that the vibration parameters as sampled directly and input to the computer sustain a high measured precision.
从而使计算机直接采样算出的振动参数有很高的精度。
From practical application, adaptive fuzzy identification and control models of proton exchange membrane fuel cell (PEMFC) were developed based on input-output sampled data and experts' experience.
从质子交换膜燃料电池(PEMFC)实际应用的角度出发，应用自适应模糊神经网络技术对PEMFC系统进行建模与控制。
It can be seen that, for simplicity, the input voltage is not sampled onto these correction bit capacitors.
可以看到，为了简化，输入电压未被采样到这些校正位电容器上。
Firstly, a PD controller is used to stabilize the inverted pendulum, and the inverted pendulum′s input and output are sampled.
首先，采用PD控制器控制倒立摆，采集倒立摆的输入输出数据；
The data processing system includes a data receiving means for receiving a plurality of input data sampled at a first frequency.
此资料处理系统包含一个资料接受装置，用来接受以第一个取样频率所取样出的一组资料。
The input signal is sampled on the falling edge of CONVST and the conversion is also initiated at this point.
输入信号在CONVST的下降沿进行采样，而转换同时在此处启动。
The input signal is sampled on the falling edge of CONVST and the conversion is also initiated at this point.
输入信号在CONVST的下降沿进行采样，而转换同时在此处启动。
应用推荐