This patented method is based on the use of a reference plate containing a stable, permanent sample film.
这种取得专利的方法是基于使用包含稳定的永久的样品薄膜的基准样片。
The experimental results indicated that the film resistivity of the sample annealed was reduced significantly and only one 3.17 of the unannealed.
实验结果表明：退火后样品的薄膜电阻率显著减小，是未退火样品薄膜电阻率的3.17分之一；
On the base of preparing rear earth ethyl salt. We obtained doped rear earth ion solid film sample of PMMA and we also tested it's absorption curve.
在制备稀土辛酸盐的基础上，得到了掺杂稀土离子的聚甲基丙烯酸甲酯(PMMA)固体薄膜试样，测得固体薄膜试样的吸收曲线。
A new type of optical storing material, the film sample of azobenzene disperse red polymer is measured by using the single beam Z-scan technique.
采用单光束Z扫描技术对新型光学存储材料偶氮分散红聚合物的薄膜样品进行了测量。
YSZ solid electrolyte film was prepared by aqueous gel casting. The influences of temperature, relative humidity and sample thickness on drying process were studied.
用水基凝胶注法制备出ysz固体电解质薄膜，研究了温度、湿度和坯体厚度对干燥过程的影响规律。
Bismuth film glassy carbon electrode was used for zinc content detection of blood sample by anodic stripping voltammetry.
采用阳极溶出伏安法用玻碳电极同位镀铋膜测定血样中的锌。
SEM showed that sample surface of passive film was grid, and crack was branch-type, and sediment on passive film was bloom shape.
扫描电镜显示，试样表面的腐蚀产物膜呈网格状，裂纹呈树枝型，腐蚀产物膜上的沉积物呈花朵状；
The concentration of dopant in the sample will be affected by the concentration of the dopant solution on the one hand and by the thickness of the film on the other.
掺杂剂溶液浓度和聚乙炔膜的厚度对试样中掺杂剂浓度均有影响；
Objective: To evaluate the influence of air oxidation, anodizing and tin coating sample on elemental composition and thickness of surface film of cast pure titanium.
目的：评价大气热氧化、阳极氧化和氮化钛镀膜对铸造纯钛表面膜组成和厚度的影响。
The observation upon the film sample indicates that a lot of dislocations and stacking faults have been formed before the formation of the martensite induced by hydrogen.
薄膜试样直接观察指出，在氢引起马氏体相变之前，氢使位错和层错大量形成。
In order to shorten test time, a forced drying method is adopted in preparing sample so as to measure gloss and colour of self-curing paint film at ambient temperature.
为缩短检验时间，采用强制干燥方法制备样板，对需要常温自干漆膜的光泽和色泽进行测定。
The volume shrinkage of the sample was lowed from 7% to 0.8%, which apparently smoothen the film.
特别是树脂的固化体积收缩率显著降低，从7％下降到0.8％，明显改善了涂膜的平整性。
Solve the problems existing in the sample of thin film with special shape by using the method of comparing fluorescence X-rays with scattered X-rays and practice the method in FP.
对于异常形状薄膜样品，存在着X射线荧光强度不足、分析位置不固定、定量值偏低的问题。
Specialized in all kinds of automotive films, the brand film, magnetron sputtering film, ceramic membrane, dimming color film, color titanium film. Can OEM sample processing custom.
专业生产经营各种汽车贴膜、品牌膜、磁控溅射膜、陶瓷膜、调光变色膜、原色钛膜。可oem来样加工定做。
The system is applicative for any shape of thin film sample including small-size and anomalous shape.
该系统能够满足对任何形状薄膜试片的电阻率测试，包括尺寸较小或者形状不规则的薄膜试片。
C... and in this condition, uniform, harder and tighter with the basal body of the sample can be gained. Moreover, more time, thicker film, but less hardness.
而且随着氧化时间的增加，可以得到相对较大的膜厚度，但膜硬度相对降低。
C... and in this condition, uniform, harder and tighter with the basal body of the sample can be gained. Moreover, more time, thicker film, but less hardness.
而且随着氧化时间的增加，可以得到相对较大的膜厚度，但膜硬度相对降低。
应用推荐