For the implantation dose determines the irradiation injury degree of biological sample, it's a important parameter that should be measured and controlled accurately in the experiment.
在离子注入生物诱变实验中，注入剂量决定了生物样品的辐射损伤程度，是要求精确测定并控制的一个重要参量。
Possibility to dope Y2O3 particle on the surface of superalloy sample and the relationship between homogeneity and irradiation parameters of laser have been investigated by means of laser irradiation.
本文通过激光辐照的方法，研究了在高温合金试样表面掺杂Y_2O_3质点的可能性、均匀程度与激光辐照参数的关系。
The frequences of heart-beat of both treating groups were greatly increased after the irradiation had stopped and the same sample had been cultured in the natural culture fluid for 24 hours.
停止辐照同一样品在自然培养液中培养24小时后，两处理组的心跳频率都大大增加。
The results are listed as following: 1 the top surface layers of CRIC and 316l SS sample were remelted under the irradiation of HCPEB. Crater-like morphology was formed on the treated surfaces.
冷轧工业纯铜及316L不锈钢处理样品表面均发生重熔现象，处理面上形成类似火山坑的显微形貌。
With increasing irradiation time, the dewatering efficiency of sample with different factors tends to be same.
随着时间的延长，试样的除湿率趋于一致并且受其他因素的影响较小。
With increasing irradiation time, the dewatering efficiency of sample with different factors tends to be same.
随着时间的延长，试样的除湿率趋于一致并且受其他因素的影响较小。
应用推荐