This paper deals with the different characteristics of the flexible and the rigid rotor balancing.
本文叙述了挠性转子动平衡与刚性转子动平衡的不同特点。
The dynamic response of unbalanced single disc rotor is analysed and theoretical aspects of flexible rotor balancing by the influence coefficient method are studied.
本文是从分析挠性转子的不平衡单质量的动态响应出发，找出用影响系数法平衡挠性转子的理论依据。
Rotor balancing of hydraulic power sets is studied by the nonlinear rotor-dynamics theory, the lots of factors are analyzed, and the geometry and mechanics models are created.
同时针对该电站水轮发电机组转子动不平衡现象，采用基于非线性转子动力学理论方法对机组动平衡进行了研究。
Balancing machine is a machine for measuring the size and position of the unbalance of a rotating body (rotor).
平衡机是测量旋转物体(转子)不平衡量大小和位置的机器。
Universal joint balancing machine: coupling drive is the use of universal joints will balance the spindle and the rotor connected.
万向节平衡机：联轴器拖动是利用万向节将平衡机主轴与转子相联接。
The difference of vibration between a mass eccentricity rotor and an initial bend rotor is analyzed. The special balancing problems of rotors caused by initial bend are discussed.
阐述了转子带有初始弯曲与质量偏心引起的转子运动之间的差异及初始弯曲给转子平衡带来的特殊问题；
This paper is concerned with balancing principle of an initial bend rotor.
对初始弯曲转子的平衡原理进行理论分析。
Furthermore, a corresponding rotor field dynamic balancing module was developed and integrated into Predictive Maintenance Studio 2000 (PMS2000).
开发相应的转子现场动平衡软件模块，集成到“PMS2000设备预知维修与故障诊断系统”。
A relative coefficient method for rotor dynamic balancing is developed based upon the influence coefficient method.
基于转子动平衡的影响系数法，本文提出了相对系数法。
To guide the application of an active balancing device in industrial cantilever rotors, a cantilever rotor test stand was set up to perform an experimental study of active balancing technology.
为了指导主动平衡装置在工业悬臂转子上的应用，搭建了悬臂转子实验台进行主动平衡实验研究工作。
A virtual balancing method of a flexible rotor based on rotor dynamic and finite element method is proposed in this paper to decrease the vibrations caused by mass unbalancing.
为了有效地降低回转机械由于质量不平衡引起的振动故障，基于转子动力学理论和有限元数值分析方法，进行了柔性转子系统虚拟动平衡研究。
The results of the above study can offer a basis and reference for the installation of an automatic balance device on a rotor and for conducting automatic balancing tests.
研究结果为转子的主动平衡装置的安装和主动平衡试验提供了参考和依据。
For a quasi steady-state active balancing system of a speed-varying rotor, according to certain time steps the varying speed of the rotor is discretized into finite constant angular speeds.
对变速转子准稳态主动平衡系统，可按一定时间步长把变转速离散成有限个转动角速度。
In chapter seven, the problem of reducing vibration in the speed-down process of a rotor system is noticed and its balancing methods are discussed in detail.
第七章研究了转子系统降速过程中过临界转速时的减振问题，讨论了其平衡方法。
The key part to realize automatic balancing of a high speed rotor is to correct the balancing head.
实现高速转子的自动动平衡的关键部件是校正平衡头。
The provision of a balancing member having an integral encoder disk facilitates the manufacture of the rotor assembly.
所提供的包括集成编码器圆盘的平衡元件便利于转子组件的制造。
The theoretical analysis of the balancing of the rigid rotor is performed by means of 8-coefficient bearing model and on the basis of taking into consideration the influence of the gyroscopic moment.
采用8系数轴承力学模型，考虑到陀螺力矩的影响，对刚性转子进行了动平衡理论分析。
The balancing member is located in a predetermined position and orientation with respect to the rotor.
平衡元件位于预定位置并相对于转子预定取向。
Meanwhile, the influence of shaft surface error on the precision of rotor dynamic balancing is analyzed, and a method is proposed to overcome it.
并分析了转轴表面误差对平衡精度的影响，得出了解决方法。
As the balancing member is located in a predetermined position, the encoder automatically assumes a predetermined position and hence the position of the rotor can be determined with certainty.
当平衡元件位于预定位置时，编码器自动显示出预定位置，因此转子的位置当然能够测定。
Finally, in the balancing test rig and the project site, the field balancing test system was use to balancing the rotor and was fully tested.
最后，分别在转子动平衡实验台和工程现场中，使用开发的现场动平衡测试系统对转子进行平衡，对系统进行全面测试。
It(?) proven that this method improves the balancing grade of high speed centrifuge, and decreases the residue unbalance of rotor. Therefore the working condition of rotor is steadily and dependable.
实际运行证明，立式双校正面平衡方法不仅改善了高速离心机及呈悬臂支承结构的转子的平衡质量，而且使转子的不平衡残余值明显降低，平衡状态稳定可靠。
A rotor dynamic-balancing experiment based on virtual instrument is developed to improve the students ability in practice.
为了培养大学生实践能力，开发了基于虚拟仪器的转子动平衡实验。
The possibility of on line easing a fume turbine's undue vibration, by means of mounting an active balancing device on its rotor, has been explored.
首先分析各类转子弯曲原因，提出利用单平面主动平衡技术消除弯曲转子振动故障，并通过实验验证这种方法的可行性。
Based on a great deal of experimental data, probe the optimal position of the first test weights of dynamic balancing of multi-bearing rotor.
在大量实验数据的基础上，探索多跨转子动平衡首次试重的最佳位置。
The rotor part is composed of shaft, middle wheel and balancing drum etc.
转子部分由轴、中轮、平衡鼓等组成。
With the measured ratio and lagging Angle, in the process of field balancing for high speed grinding, the rotor system can attain quick balance just adding balancing mass one time.
利用测出的比例常数和滞后角，对高速磨削过程中出现的不平衡振动，可实现转子系统一次试加重的快速动平衡。
Main rotor is put through precision balancing tests to ensure smooth operation, minimal vibration, lower noise and more reliable performance;
◎主转子经过高精度的动平衡检测，确保运转平稳、振动微小、噪音更低、性能更可靠；
The assembly further comprises a balancing member 40, from which material may be removed for balancing the rotor assembly.
组件进一步包括平衡元件(40)，可以从该元件去除材料以平衡转子组件。
The assembly further comprises a balancing member 40, from which material may be removed for balancing the rotor assembly.
组件进一步包括平衡元件(40)，可以从该元件去除材料以平衡转子组件。
应用推荐