The Internet has been rolling along for decades on the strength of IPv4 and its numbering system, which has supplied billions of addresses.
互联网在IPv4及其编号系统的助力下，在几十年的时间里提供了亿万个地址。
The results indicated that increasing the deformation and a proper rolling temperature may improve obviously the bonding strength.
研究表明，增加变形程度和选择合适的轧制温度能提高复合板的界面初结合强度。
Compared with the strip produced by conventional austenite rolling, the yield strength of the ferrite rolled strip was lower by about 20%, with same elongation and strain hardening exponent.
相对于常规奥氏体轧制，铁素体轧制薄板的屈服强度下降了20%左右，伸长率及应变硬化指数与之相当。
Disclosed is a wrought magnesium alloy having excellent strength and extrusion or rolling formability, and a method of producing the same.
公开了一种具有优秀强度和挤压或轧制成形性的变形镁合金，以及该变形镁合金的制造方法。
The effects of rolling and annealing temperatures on the shear strength of titanium cladding steel plate were investigated.
研究轧制温度、退火温度对复合板剪切强度的影响。
The results show the strength of the tested steels was increased and hole expanding ratio was decreased with the decrease of final rolling temperature or coiling temperature.
试验结果表明，随着终轧温度或卷取温度的降低，试验钢强度提高，而扩孔性能降低。
This article proves that rolling operation can largely enhance fatigue strength through the research on the cold rolling operation of thread root of the drilling tool joint.
通过石油井下钻具接头螺纹冷滚压工艺的研究可以证明冷滚压可大大地提高接头的疲劳强度。
This paper introduces a kind of new method of cool rolling, shock and rolling, for making rounds of high strength bolts. Its working principle and test results are described.
介绍了一种用于高强度螺栓圆角冷滚压的新方法——冲击滚压，简述了它的工作原理及试验结果分析。
The results indicate that, with the increase of rolling times, the grain size becomes smaller, the content of sorbite multiplicates, and the yield strength improves.
结果表明，随轧制道次的增加，晶粒尺寸逐渐减小，索氏体的含量不断增加，屈服强度逐渐提高。
Roll collar, needing not only high strength and wear resistance but also thermal fatigue resistance and corrosion resistance, was one of the components which were damaged easily in rolling process.
轧辊不仅需要具备高强度和高耐磨性，还必须具有高的抗热疲劳强度和耐腐蚀性以及抗氧化性，是轧钢行业的主要消耗件之一。
It is required that BS700MC has not only high strength but also good formability, shock resistance and weldability and that the rolling loads are not high in the production line.
合理的成分是保证BS 700 MC性能的基础。BS 700 MC既要求高的强度，又要求具有良好的成形性能、低温冲击性能和焊接性能，同时还要考虑批量生产时的轧机负荷问题。
With little increase in cost of steel making, the steel with good combination of strength and plasticity and satisfied toughness at low temperature can be produced by controlled rolling and cooling.
在几乎不增加冶金成本的前提下，试制钢板具有优良的强度、塑性配合，优良的低温韧性水平。
Compared with Bengang 1700 hot rolling mill, the strip rolling product has smaller crystal granularity, higher strength value, and lower extension rate.
从热轧产品看：与本钢1700热连轧机相比，晶粒尺寸略小，强度值略高，延伸率略低。
This paper analyses the working principle of crankshaft 's strength and alignment by rolling and studies the crankshaft rolling and aligning expert system.
分析曲轴圆角滚压强化和滚压校直的工作机理，研究曲轴滚压校直专家系统。
Any mechanical operation that creates permanent deformation, such as bending, rolling, drawing, etc. performed at room temperature that increases the hardness and strength of the stainless steel.
引起材料永久变形的机械操作，如弯曲、辗制、拔制等。在室温下操作，提高不锈钢的硬度及强度。
The steels can obtain better strength and toughness by subsequent air cooling after hot forging or rolling without any heat treatment.
本钢种无需经过任何热处理，经锻轧后空冷就能达到较好的强韧性。
Surface defects in ceramic bearing balls may significantly affect ball strength and reduce rolling contact fatigue lifetime.
陶瓷轴承球的表面缺陷会严重降低球的强度和滚动接触疲劳寿命。
Applying the deep rolling depression technology to engine crankshaft fillets can greatly improve their fatigue strength.
发动机曲轴圆角采用深滚压工艺可大幅提高曲轴疲劳强度。
The fatigue strength of commercial purity titanium was improved through shot peening or cold rolling treatment.
工业纯钛经喷丸、滚压强化后，疲劳强度得到不同程度的提高。
By controlling hot rolling temperature and cooling rate, the strength of the steel can be increased while the magnetic flux density will not be affected.
通过控制轧制、控制冷却，可提高钢的强度、而不损害钢的磁通密度。
The strength and the plasticity of the alloy can be changed in a wider range along the increase of the rolling deformation amount, which can satisfy the requirements of different industries.
随着轧制变 形量的增加，合金的强度和塑性可以在一个较宽的范围内变化，可以满足不同工 业的需求。
The result shows that production of high strength screw bars is reasonable by the control rolling and control cooling process on high-speed wire mill with the capacity of low temperature rolling.
结果表明，在具有低温轧制能力的高线轧机生产线上，采用控轧控冷工艺生产高强度钢筋是可行的。
Based on the production condition, a rational cooling schedule was established for improving the product strength and malleability to fit the subsequent cold rolling process.
为提高产品的强度及韧性，适应以后的冷轧工艺，根据某厂现场条件，制定了合理的冷却制度，效果良好。
Finish rolling temperature showed great effect on yield strength and impact toughness of low V-bearing steel, but showed no obvious effect to the high V-bearing steel.
终轧温度对低V钢的屈服强度和韧性存在显著影响，但对高V钢的组织性能影响不大。
Big ferrites and hot rolling texture are left behind in particle structures, Which leads the anisotropy of mechanics, so the tensile strength and elongation rate reduce.
含有粗大的铁素体晶粒和残留的热轧织构，引起力学性能的各向异性，导致了抗拉强度和延伸率的降低。
This paper studied the new method of deep drawing of cold rolling steel-metal part and the die structure. And it also proposed the strength calculation method of main die component.
研究了冷轧薄钢板零件的深拉伸新方法和模具结构，提出了模具主要元件的强度计算方法。
Focuses on the strength analysis of slipper type universal coupling which is the 650 rolling mills key load-supporting structure.
对650轧机关键受力部件——滑块式万向接轴进行强度分析计算。
New evaluation methods for fragile shale are introduced, including improved hot rolling test, filter cake strength tester, and dynamic filtration test.
介绍了硬脆性泥页岩稳定性评价的几种新方法——改进的热滚分散法、泥饼强度测试法及动滤失试验法。
The results show that the rolling will make the grain fine, the tensile strength increased and the prolongation rate reduced.
分析结果表明，轧制变形使板带晶粒细化，抗拉强度增加，伸长率降低；
The results show that the rolling will make the grain fine, the tensile strength increased and the prolongation rate reduced.
分析结果表明，轧制变形使板带晶粒细化，抗拉强度增加，伸长率降低；
应用推荐