The reason that the residual test method based on Kalman filter is insensitive to sensor soft fault detection is analyzed.
分析了基于卡尔曼滤波器的残差检验法对传感器缓变故障检测的不敏感性原因。
It was used in grey forecasting for the leaching rate of a laboratory simulation test on an uranium ore and "residual test method" and "grey relevance degree test method" were used for checking.
应用该模型对某铀矿石室内模拟试验的浸出率进行灰色预测，采用“残差检验法”和“灰关联度检验法”进行检验。
Test results indicate that the method can be used to measure the distribution and the value of the residual stress, which provides a scientific reference for structural engineers.
检测结果表明，该方法可以有效地测出钢管内部残余应力的大小与分布，可为结构设计提供理论依据。
For the disadvantage of tracking the soft failure of the residual test based on Kalman filter, this paper makes an improvement on the method by using the state propagator.
针对基于卡尔曼滤波器的残差检验法会跟踪软故障的局限性，提出了一种基于状态递推器的改进方法。
According to the test data and field data of transmitter and receiver, the method of "maximum mean residual life" is used to determine an optimum burn-in time.
根据发送器和接收器的老化试验数据和现场数据，使用“最大平均剩余寿命”的方法分析确定了一个较优的老化时间。
It used the moving least square approximation as a trial function, and used the weighted function of the moving least square approximation as a test function of the weighted residual method.
这种方法采用移动最小二乘函数来近似解变量，并且采用移动最小二乘近似函数的权函数作为加权残值法的权函数。
A method of predicting the residual creep life of aluminum alloy 2a12 by using indentation test method with flat cylindrical indenters was proposed.
基于平头压痕理论和蠕变损伤理论，提出了采用平头压痕试验和拉伸蠕变试验相结合的方法来确定铝合金2a12的蠕变剩余寿命。
Objective To study the efficacy of filtration-rinse method in removing residual disinfectant in the test for evaluation of germicidal efficacy of chemical disinfectant.
目的研究过滤冲洗法在评价化学消毒剂杀菌效果的试验中去除残余消毒剂的效果。
The test method for determining residual vinyl chloride monomer content in parts per billion level in PVC resin by capillary column gas chromatography headspace technique is suggested.
提出用大口径毛细管顶空进样气相色谱法对聚氯乙烯树脂中十亿分之一级残留氯乙烯含量的测量方法。
The principle and the basis of design are introduced. The construction of the system and the preliminary test are given. The method of detecting beam profile by residual-gas is verified.
介绍了剩余气体束流剖面探测系统的工作原理和设计依据，描述了所设计的系统结构并进行了初步实验，证明了利用剩余气体探测束流剖面的方法是可行的。
The principle and the basis of design are introduced. The construction of the system and the preliminary test are given. The method of detecting beam profile by residual-gas is verified.
介绍了剩余气体束流剖面探测系统的工作原理和设计依据，描述了所设计的系统结构并进行了初步实验，证明了利用剩余气体探测束流剖面的方法是可行的。
应用推荐