The paper does an in-depth research on the numerical model of pyrolysis process of the materials with volatile residual layer by using pre-evaluation iteration method.
采用偏微分数值模型,使用热解界面预估循环迭代的方法,对存在可变残留层材料的热解过程进行了详细研究。
For the removal of residual layer after template is released during nanoimprint lithography, a new UV-nanoimprint technology without residual layer based on photolithography mask was proposed.
针对纳米压印光刻技术中压印脱模后的留膜去除问题,提出了一种基于光刻版的无留膜紫外纳米压印技术。
The residual resistance factors and the depleted layer thickness of Xanthan solution decrease with injection speed increase, but recovery does not vary much.
注入速率增加时,黄原胶溶液的残余阻力系数下降,衰竭层厚度降低,采收率变化不大。
In the evening, the sunset mountain residual light shone golden yellow like spread a layer of gold on the hillside.
傍晚,夕阳的残光把山坡照得金黄金黄的就像在山坡上铺了一层金子。
The pit then grows through the compressive layer, and the change in residual stress state and the pit geometry initiate stress corrosion cracking.
随后斑点穿过压缩层继续扩展,剩余应力发生改变,斑点最终导致应力腐蚀裂纹。
Residual compression ACTS on the plastic deformation layer.
残余压应力作用在塑性变形层内。
Test shows that the depth of residual compressive after chemical heat treatment is correspondent with that of diffusion layer.
试验表明,化学热处理后残余压应力的深度往往与渗层深度相一致。
Restoration of the shot-peened layer during overhaul is important to ensure that the shot-peen compressive residual stresses are maintained or restored.
大修中喷丸层的恢复相当重要,确保喷丸压缩层的剩余应力大修或应力恢复。
The results indicate that it's possible that both tensile stress and compressive stress exist in the same layer of the unsymmetrical laminates due to the existence of residual bending stress.
指出非对称型层合材料由于弯曲应力的存在,可产生残余弯曲变形并使残余应力沿厚度方向交替变化。
Phase transformation sequence in diffusion layer and the existence of residual austenite have great effect on the distribution of residual stress.
渗层中的相变次序和残余奥氏体的存在对残余应力分布影响较大。
Minish the well space and increase transflux routeways upper backwater and driving, especially setup precipitation well and drain residual water at the bottom of diving layer.
减小井间距,增加上层滞水和潜水的入流通道,尤其要在潜水含水层底板低洼处设置降水井将低洼处的残留水引走。
The carbonide in the recarburized layer is mainly M23C6. The martensitic zone is composed of dislocation martensite, twinning martensite, residual austenite and a little carbonide.
增碳层中的碳化物主要为M_(23)C_6。马氏体带由位错马氏体、孪晶马氏体、残余奥氏体和少量碳化物组成;
Compared with the dry-grinding, the surface compress residual stresses of the hardened layer under wet-grinding is increased, but its depth of hardened layer reduces about 30%.
与干磨相比,湿磨硬化层表面残余压应力有所提高,但其硬化层深度减少了约30%。
Residual stress profile state and surface roughness are the two important parameters for evaluating machined surface layer quality.
残余应力分布状态及表面租糙度是评定加工表面层质量的两个重要参数。
The formation mechanism of oxide layer and the relationship between the oxide and the residual life of high temperature component had been introduced in this paper.
对高温构件的氧化层形成机理以及内氧化层与炉管剩余寿命的相关关系进行了阐述。
This paper demonstrates residual stress of induction quench parts and personal views about stress distribution of flange corner heat treatment, truck half axle material and depth of hardened layer.
论述了感应淬火零件的残余应力形态,并对载货车半轴的材料、硬化层深度及法兰圆角淬火层分布提出了个人见解。
After heat treatment, the residual austenite is decreasing and carbides are increasing. The hardness of the surfacing layer is higher than that as welded.
经过热处理后,堆焊层中残余奥氏体的量明显减少,碳化物进一步析出,使得堆焊层的硬度比焊态下有了较大的提高。
The demonstrated decrease of surface residual stresses testifies the removal of the former deformation layer.
针对表面残余应力的计算也证实了表面加工变质层的有效去除。
Therefore it is very important to estimate production layer, determine planar distribution of press and residual oil, and investigate its characteristics.
因此对产层进行评价,确定地层压力和剩余油等参数的平面分布,由此研究其特点具有十分重要的意义。
Recommend washing dishes at the first step should be stripped of vegetables for outer layer, the outer leaves residual pesticide on the inside of the more than.
建议洗菜时第一步应该剥去蔬菜外层,因外层叶子上残留的农药比里面的多。
Residual stresses are generated in the machined layer for high-speed machining. The residual stresses impacts the working performance and fatigue strength of parts.
高速切削加工时,已加工表面存在的残余应力影响工件的使用性能和疲劳强度。
The bilayer cantilevers, formed with a polysilicon layer and a gold layer, elevate the mirror plate according to residual stress-induced bending.
支撑臂由多晶硅层和金层构成,在残余应力的作用下发生弯曲而将镜体提起。
That method was used for calculating the residual stress of laser cladding layer of the hermetic surface of valves. There is good agreement between our results and the others quoted from literature.
对气门密封面激光熔覆钴基合金层的计算结果显示,显微压入硬度法得到的残余应力分布数据与其它方法测得的激光熔覆层残余应力分布数据具有相同的变化趋势。
Any residual plates in awarding the shadow layer composed of net-point edge will not form irregular business card printing and membership card making.
任何由残留印版未不退影图层组成的网点边际都不会变成不法规的制卡和会员卡制作成果。
Horizontal well tech is an effective way to dig potential of residual oil enrichment part above normal rhythm thick oil layer with high water content.
水平井技术是挖潜特高含水期正韵律厚油层顶部剩余油富集区最有效的方法。
The residual amount of ethylenediamine tetracetic acid (EDTA) in canned food products was determined by adopting thin-layer chromatography (CTLC).
采用薄层色谱法,测定罐头食品中EDTA(乙二胺四乙酸)的残留量。
It is analyzed of the residual stress generating procedure in adhesive coating layer on the surface of port crane parts for the purpose of surface protection or repairing.
分析了用于港机部件表面保护和修复的涂层中通常存在的内应力的产生过程,认为它是导致涂层早期破坏的主要原因之一。
It is analyzed of the residual stress generating procedure in adhesive coating layer on the surface of port crane parts for the purpose of surface protection or repairing.
分析了用于港机部件表面保护和修复的涂层中通常存在的内应力的产生过程,认为它是导致涂层早期破坏的主要原因之一。
应用推荐