With the effective utilization of this machine and other equipments of the assembly line, the reducer assembly quality and the automobile's drive bridge performance are improved greatly.
本产品和装配线上的其它设备的有效利用，全面提高了汽车驱动桥主减速器的装配质量和驱动桥的整体性能。
To calculate the number of teeth in the design, profile analysis, efficiency calculation and checking the strength, structural design, drawing reducer assembly drawings and part drawings.
在本次设计中要进行齿数计算、齿形分析、效率计算、强度验算、结构设计、绘制减速器装配图及零件图。
The assembly quality of automotive rear axle differential reducer is an important factor for the entire car performance.
汽车后桥差减速器的装配质量是影响整个汽车性能的一个重要因素。
This system makes use of the technique of database searching and language VBA to complete the whole process of indexing reducer model from data table and drawing the assembly drawing.
该系统利用数据库查询技术和VBA开发工具完成从数据表中检索减速器型号及主要参数，并利用几何参数生成装配简图的全过程。
Theoretical research and experimental results of this paper illustrate that the gear assembly adjustment is an important factors of impacting vibration and noise of the main reducer.
本文的理论研究和实验结果都说明了齿轮的装配调整是影响主减速器振动和噪声大小的重要因素。
Automotive drive axle of the main reducer and differential assembly is a key automotive power train components.
汽车驱动桥中的主减速器及差速器总成是汽车传动系的关键部件。
Prototype system verified by the reducer, indicates the feasibility and validity of assembly information building, assembly sequence planning and evaluation.
本文原型系统通过减速箱装配体加以验证，表明了装配信息建模、装配顺序规划及其评价的可行性和有效性。
To determine the internal gear pair design parameters of two-stage internal contact involute planet gear reducer all constrained conditions from machining to assembly must be satisfied.
确定双内啮合渐开线行星齿轮减速器内齿轮副的设计参数，从制造到安装有许多限制条件。
For example, the main driving axle reducer seal assembly technical requirements: input flange oil seal centerline hole of the center line of the small eccentricity of more than 0.1mm.
例如驱动桥主减速器油封的装配技术要求：输入法兰中心线对油封座孔中心线的偏心度小得超过0.1mm。
For example, the main driving axle reducer seal assembly technical requirements: input flange oil seal centerline hole of the center line of the small eccentricity of more than 0.1mm.
例如驱动桥主减速器油封的装配技术要求：输入法兰中心线对油封座孔中心线的偏心度小得超过0.1mm。
应用推荐