To their surprise, they discovered that its rate of bending depended on the liquid's viscosity, and moreover that this rate could be determined from the cantilever's electronic readout.
他们惊讶地发现，悬臂弯曲的角度和液体的粘稠度具有线性关系，而悬臂的弯曲度可以通过电子设备读出。
It shows that after adding 20% low profile additive to the UP resin, the shrinkage rate of cured resin is 2.1%, the retention rate of bending strength is 88% and no change in flexural modulus.
结果表明，在不饱和聚酯树脂中加入2 0 %的该类低收缩添加剂，树脂的固化收缩率为2 1% ，弯曲强度保有率为88% ，弯由模量没有明显变化；
A study has been done over the small crack growth rate for kinds of carbon steels under push pull and rotating bending.
对多种碳素钢在拉伸压缩和旋转弯曲负载下的微小裂纹扩展速率进行了研究。
The stress shielding rate, bending strength of different directions and torsion strength of the three different fixation methods were measured and compared.
然后对三种固定方法对固定骨段的应力遮挡率、不同加载方向的弯曲强度和扭转强度进行测试。
We researched the effect of powder NBR on thermal properties and mechanical properties of phenolic resin, including the binder flowability, curing rate, bending strength and Rockwell hardness.
研究了在酚醛树脂中添加丁腈橡胶粉末对粘合剂的流动性、固化速度、弯曲强度和洛氏硬度等性能的影响。
It indicates that there are significant differences for microfibril Angle, basic density, bending strength and rate of shrinkage of poplar 63 and poplar 69 by variance analysis.
方差分析表明：63杨、69杨微纤丝角、基本密度、抗弯强度和干缩率差异显著，说明63杨和69杨受滩地类型影响较大。
Effects of temperature on impact strength of PVC and the effects od load rate on mechanical properties under tension and bending load of PVC are Studied.
本文研究了加载速率对PVC拉仲、弯曲性能的影响规律及试验温度对PVC冲击强度的影响。
Results showed that ferrite net and lower hardness due to low cooling rate, coarser finish machining resulted in the fracture during earlier stage of rotary bending fatigue test.
结果表明，冷却不足使组织中出现网状及小块状铁素体，导致硬度偏低，加之磨削加工痕迹较粗是引起前轮毂早期断裂的原因。
Comparisons were conducted on the catheter bending rate, dislocation rate, obstruction rate, oozing of puncture point and catheter insertion time.
比较两组患者的置管意外(导管折叠、脱出和阻塞)发生率、穿刺点渗血情况和置管时间。
The rate of injuries in occupational settings has increased in recent years, and more than one half are back injuries resulting from improper lifting and bending techniques (Owen and Garg, 1991).
最近几年，专业机构的受伤比例增加，其中一半以上是由于搬运及弯腰操作为当。
The rate of injuries in occupational settings has increased in recent years, and more than one half are back injuries resulting from improper lifting and bending techniques (Owen and Garg, 1991).
最近几年，专业机构的受伤比例增加，其中一半以上是由于搬运及弯腰操作为当。
应用推荐