The numerical model of the linear optical amplifier (LOA) is built based on the rate equations. The gain clamping characteristics of LOA are simulated.
基于速率方程建立了线性光放大器(loa)的数值模型，模拟了线性光放大器的增益钳制特性。
The model is based on the semiconductor laser rate equations and the structure of the VCSEL chip, and every element in the circuit is represented.
等效电路的提出是基于半导体激光器速率方程以及VCSEL芯片结构，电路中各元件都有严格的物理意义。
Fatigue damage estimation of the tendons was made using fracture mechanics approach, establishing the fracture crack growth rate model and limit state equations for failure modes.
疲劳寿命的计算采用断裂力学方法，建立疲劳裂纹扩展模型和失效模式的极限状态方程。
A simple equivalent circuit model of quantum well laser (QW LD) which is derived by QW rate equations and is accomplished in the circuit simulation program SPICE.
给出一个新的量子阱激光器等效电路模型，由量子阱激光器单模速率方程推导得到并在电路模拟程序SPICE中完成。
According to structural property of linear optical amplifier (LOA), a model was built using rate equations.
针对线性光放大器(loa)的结构特点，建立了基于速率方程的模型。
Starting from the rate equations and the theory of multilayer dielectric film, a dynamic transfer matrix model of vertical cavity semiconductor optical amplifiers (VCSOAs) was established.
从速率方程和多层介质膜理论出发，构建了垂直腔半导体光放大器(VCSOA)的动态传输矩阵模型。
Based upon the laser rate equations including relaxation between energy levels, the optimum model of a multipass amplifier is constructed.
由包含弛豫作用的速率方程出发，建立了关于放大器能流密度空间分布最优问题的数学模型。
A theoretical model has been established based on the solution of the rate equations for the erbium-doped fiber ring laser (EDFL).
通过求解速率方程，建立了环形掺铒光纤激光器的理论模型。
The MPI of molecular ions model was analyzed with rate equations.
并用速率方程对母体离子阶梯模型的多光子电离进行了分析。
The model of EDFA that has been made is modified by considering the base loss of erbium-doped fiber and ase. The rate equations and propagation equations that have been modified are given.
本文所建立的EDFA的理论模型考虑了ASE和光纤的本征衰耗，修改了速率方程和传输方程。
The model includes reaction rate equations, gas-liquid equilibrium and gas-liquid mass transfer equations, so that the simulation gives close results to the commercial practice.
数学模型中包括了反应动力学方程、气液平衡和气液传质方程，使模拟结果接近于工厂实践。
Discusses several representative equations of point source plume. Establishes calculating equations of thermal stratification height, ventilation rate and neutral level based on a two-zone model.
讨论了几个典型的羽流流量计算公式，结合一种二区自然通风模型，建立了热分层高度、通风量和中和界高度的计算式。
Discusses several representative equations of point source plume. Establishes calculating equations of thermal stratification height, ventilation rate and neutral level based on a two-zone model.
讨论了几个典型的羽流流量计算公式，结合一种二区自然通风模型，建立了热分层高度、通风量和中和界高度的计算式。
应用推荐