In addition, the surface-smoothing effect of wearing material reduces pump load. Taking No.
防磨材料表面光滑作用减少了泵的负载。
And installed the overload protection, namely to ensure that motor and pump load pressure switch.
并安装了超载保护，即保证电机及油泵负荷的压力开关。
The pump is rated pressure pump work for the highest allowable pressure, but their work is determined by external pressure load, pump life are directly related to their work pressure.
泵的额定压力是指泵连续工作时的最高许用压力，而其工作压力则决定于外部负载，泵的寿命与其工作压力直接相关。
Pump is the drainage and back into the groove of reasonable design, is a gear in the work under the minimum torque force, so the bearing load is small, wear small, pump with high efficiency.
输送皂角泵内有设计合理的泄油和回油槽，是齿轮在工作中承受的扭矩力最小，因此轴承负荷小，磨损小，泵效率高。
If the first gear pump operation, or long-term idle after use, preferably in small load or no-load circumstances Xianpao One hour.
齿轮泵若是第一次运行，或长期闲置后再使用，最好在空载或小负荷情况下先跑合一小时左右。
The se water pump motor is unable to meet the operation requirement when its load current adjacent to its rated current. Please select another one with a large capacity.
海水泵电动机当其负载电流接近额定电流时不能满足运行要求，请选择另 一台容量大的电动机。
The se water pump motor is unable to meet the operation requirement when its load current adjacent to its rated current. Please select another one with a large capacity.
海水泵电动机当其负载电流接近额定电流时不能满足运行要求，请选择另一台容量大的电动机。
The waterfeeding recirculation header pipe will be set between water-feeding pump and deaeration water tank to fulfill requirements for start-up and low load operation of waterfeeding pump.
在给水泵与除氧水箱之间，设置给水再循环母管，以满足给水泵在启动及低负荷运行时的需要。
Based on the analysis on all kinds of load while the pump valve is working, we establish the corresponding mechanical model.
对泵阀工作时的各种载荷进行了分析，建立了相应的力学模型。
The radial piston pump can adopt manual-control or electro-hydraulic proportional control to realize the control of constant flow, constant pressure, constant power and load sensitivity etc.
径向柱塞变量泵可以采用手动控制、电液比例控制或负载敏感控制等多种控制方式，实现恒流量、恒压力、恒功率的控制。
The calculation and design procedures of air conditioning load, ground loop heat exchangers, radiant floor system, distribution system between heat pump and build are mainly introduced.
重点介绍了建筑空调负荷计算、地下埋管换热器系统、辐射地板系统以及热泵和建筑物内分配系统设计等方面的内容。
These problems are made in a sealed diving sewage pump, electrical load-bearing capacity, bearing arrangement and requirements for the use of the sewage pump than the average higher.
这些问题都使得潜水排污泵在密封、电机承载能力、轴承布置及选用等方面的要求比一般的污水泵要高。
Q. I have a rattling noise coming from the backend of my pump while it is under load. What is happening?
问题当运行后，水泵背部发出卡塔·卡塔的声音。发生了什么？
When the load of pump control cubage timing system changes, the motor output speed must be kept steady.
泵控容积调速系统中负载发生变化时，要保证马达输出转速恒定。
There are many factors that influence impact and vibration in hydraulic systems, such as pump structure, valve parameters, load, pipe design and operation conditions.
影响液压系统冲击、振动的因素很多，如泵的结构、阀的参数及负载情况和整个系统管路设计的合理性、工作条件等。
It is the effective countermeasure against throttling loss in pumps to adopt speed regulator, so as to adjust pump speed according to load variation.
采用调速技术，使输油泵适应负荷变化，改变转速来调节输油泵的运行点，才是解决泵节流损失的措施。
Different outdoor temperature of the gas engine heat pump under the heat load for the heat, heat the remainder of the engine, the system changes in a power relationship.
不同室外温度下的燃气机热泵热负荷、供热量、发动机的余热量、系统一次能耗的变化关系。
This article is concerned with the study on the pump pressure distribution against drilling-time and the load pattern of slush pumps.
本文论述了钻井泵载荷谱的编制方法、泵压对钻时的分布规律及载荷谱的应用。
The results show that guide bearing load of large vertical water pump has something to do with inlet passage of pump station, pump unit manufacture and installation quality, structure pattern.
研究结果表明：大型立式水泵导轴承荷载与进水流道和机组制造安装质量、结构形式有关。
If we compensate the pump station with lower power Numbers for electric power and electric capacity we can reduce the current load in the power source and the lines.
对已建成的功率因数偏低的泵站采用电力电容补偿，可减少电源和线路的电流负荷。
Electro-hydraulic proportional sectional valves are realized with load sensing control, and the pump output power is adaptive to load, the system effectiveness is highly enhanced.
通过对电液比例多路阀进行负载敏感控制，实现泵和负载之间的功率匹配，显著提高系统效率。
All these problems make diving sewage pump in a sealed, the electrical load capacity, bearing arrangement and the use of requirements than the average sewage pump higher.
这些问题都使得潜水排污泵在密封、电机承载能力、轴承布置及选用等方面的要求比一般的污水泵要高。
Pump are not allowed to bear load of pipeline.
泵不允许承受管路的负荷。
In some implementations, there is a feedback signal from the load to the charge pump.
在一些实施方案中，存在从负载到电荷泵的反馈信号。
This dissertation has analyzed the full-load speed characteristics of the diesel engine, some load tempo characteristics and characteristics of variable pump at first.
本文首先分析了发动机的全负荷速度特性、部分负荷特性和变量泵在不同的工况下的效率特点。
The energy-saving effects are influenced by the efficiency of transducer, motor, pump and distribution of load;
系统的节能效果还受变频器效率、电机效率、水泵效率及负荷分布的影响；
A new method that hydraulic pump constant flow regulating is realized by using the principle of identifying the load flow with neural network is proposed.
提出一种采用种经网络辨识负载流量原理实现液压泵恒流量调节的新方法。
Recent years, the seasonal energy efficiency(SEER)and integrated part-load value(IPLV)are the evaluating methods for refrigeration and heat pump equipment.
季节能效比（SEER）和综合部分负荷值（IPLV）是近年来出现的制冷和热泵装置能源效率评价指标。
Therefore, in the lower part load, the gas engine heat pump at a lower energy efficiency.
因此在部分负荷较低的情况下，燃气机单级离心泵的一次能源利用率较低。
Therefore, in the lower part load, the gas engine heat pump at a lower energy efficiency.
因此在部分负荷较低的情况下，燃气机单级离心泵的一次能源利用率较低。
应用推荐