A molding control device is designed using Programmable Controller (PLC) as a primary controlling component.
本文采用可编程控制器(P LC)为主要控制元件，研制出一台成型控制装置。
This article introduces a new method of design electronic products with the EDA software and the FPGA programmable logic component.
采用EDA软件和FPGA可编程逻辑器件进行电子设计，以电子秒表为例，说明设计过程和方法。
Investigates its reason, possibly on card, in the product has not used on the monolithic integrated circuit or other programmable logical component.
究其原因，可能就卡在产品未使用单片机或其它可编程逻辑器件上。
Difficulty of system Extending and transplant are found by means of PCI (Peripheral Component Interface) bus motion controller or PC (Programmable controller).
系统的扩展和移植难度发现的PCI(外设组件接口)总线运动控制器或PC(可编程控制器)的手段。
Difficulty of system Extending and transplant are found by means of PCI (Peripheral Component Interface) bus motion controller or PC (Programmable controller).
系统的扩展和移植难度发现的PCI(外设组件接口)总线运动控制器或PC(可编程控制器)的手段。
应用推荐