The PAN-1 high effective flocculant not only raised the capacity of settling tank in sintering process, but also lowered overflow suspensions and reduced water into the process.
PAN-1型高效絮凝剂在试验过程中，不但提高了烧结法分离沉降槽的产能，而且降低了溢流浮游物，减少了进入流程中的水。
Endocrine disrupting compounds in tap water mainly stem from the pollution of raw water for water supply, concrete tank and lining of still pipe in water supply system, and chlorination process.
残留在自来水中的内分泌干扰物质的来源主要包括水源污染，配水管网及这些化合物质在氯消毒过程中的副产物。
Through study on the influencing factors in coking waste water treatment process, AAO waste water treatment process is optimized, the anaerobic tank has been modified.
通过对焦化污水处理过程影响因素的研究，优化了aao污水处理工艺，对厌氧池进行了改造。
Water deodorization, it mainly apply for cleaning waste tank contents, manufacturing or process water or wastewater.
主要应用在清洁污水罐，生产工艺污水。
The paper introduces the project of treatment of the oily waste water in the residue oil tank zone by advective separation of oil-blending and solidification gas-floating-coke filtration process.
介绍了采用平流隔油-混凝气浮-焦炭过滤工艺处理渣油罐区含油废水的工程情况，经该工艺处理后的废水达到国家一级排放标准。
An intermediate tank is used to receive the discharge water from each process and provide water to operations in batch processes, which increased reuse of process discharge streams.
该方法采用一个中间贮罐用来接收各单元操作的排水，增加各单元操作之间的水再利用机会。
The water injection leak-stoppage process that is adopted during leak accident of LPG tank is discussed.
讨论了LPG储罐发生泄漏事故时采取的注水堵漏工艺。
First, this thesis analyzed the manufacture process, static and dynamic characteristics of three-tank water level control system.
本课题首先深入分析了三容水箱液位控制系统工艺流程及其运行过程的静、动态特性。
The discussion of water injection process to seal leakage occurred in LPG tank was carried out in this article.
讨论了LPG贮罐发生泄漏事故时采取的注水堵漏工艺。
The invention organical combination the stripped process of the sour water and the purifying treatment process of the sour water storage tank discharging, achieves perfect purifying treatment effect.
本发明方法将酸性污水汽提工艺与酸性污水储罐排放气净化处理过程有机结合起来，达到理想的净化处理效果。
Based on the Monte Carlo MCNP code, the changes of radiation dose at the shield water tank surface during the process of lost water is studied.
基于蒙特卡罗方法的MCNP程序，研究了反应堆屏蔽水箱失水过程中的水箱表面辐射剂量的变化情况。
Flotation-sedimentation tank was an effective process for treatment of low temperature and low turbidity water and algae-laden water, and it was also fitted for sudden occurrence of high turbidity.
浮沉池工艺适应于低温低浊水和高藻水的处理，并能很好地应对突发的高浊度。
The system is composed by following structures: a demineralized water tank for receiving qualified condensed water in mother liquid evaporation or autoclave leaching process;
它由下述结构构成：接收母液蒸发或压煮溶出工序合格冷凝水的软水槽；
For seasonal ammonia and organic micro-polluted raw water, biological sludge in sedimentation tank following bio-pretreatment was returned to flocculation tank, to enhance conventional process.
针对季节性氨氮和有机微污染水源，通过回流生物预处理后沉淀池生物污泥至絮凝池，进行常规生物强化处理。
In the process of cleaning, after the discharged dirty hot water enters into a backwater tank, the hot water can preheat the cold water in a preheating tube and the residual heat is fully utilized.
清洗中所排出的污热水进入回水箱后，可对预热管内的冷水进行预热，能充分地利用余热。
The design of tank structure, washing water system, aeration system and sludge discharge system are described , and the advances and attentions in application of this process are reviewed.
结合该厂水质、水量特点，分析了UNITANK工艺的池型、冲洗水系统、曝气系统、污泥排放系统的选择与设计，并总结了该工艺的优点及应用中的注意事项。
The design of tank structure, washing water system, aeration system and sludge discharge system are described , and the advances and attentions in application of this process are reviewed.
结合该厂水质、水量特点，分析了UNITANK工艺的池型、冲洗水系统、曝气系统、污泥排放系统的选择与设计，并总结了该工艺的优点及应用中的注意事项。
应用推荐