Also it supplies sealing water to the sealed part of the primary reactor coolant pump.
同时该泵还向核主泵提供密封水。
This pump removes the heat of the primary reactor coolant after the reactor is stopped and lowers its temperature.
该泵用于在反应堆停止时排除主回路的热量并降低其温度。
This pump supplies make-up water to maintain the volume when the primary reactor coolant has contracted due to decrease of load.
该泵在主回路冷却水减少时，提供补充水以维持所需水量。
When you have an event, the reactor is operating at full power, you blowdown the primary coolant which is hot, you start injecting emergency core cooling water which is cold.
当你进行的时候，反应堆就会用全部的动力，运行，你排放出初冷却剂，那是热的，你开始注入紧急核心冷却水，那是冷的。
There are reactor coolant system weld issues, they're used and they're getting primary water stress corrosion cracking.
还有反应堆冷却剂系统焊接问题，它们使用了并且得到原生水,应力腐蚀裂痕。
We also need to cool the reactor and the spent fuel in the spent fuel pool but that basically means you wanna maintain the coolant inventory which means water in the primary system.
我们也需要冷却反应堆，还有乏燃料,在乏燃料池里，但是那基本上意味着,你们想要维持冷却剂存货,也就是在主系统中的水。
So we're talking about a reactor that has a break in the primary cooling system and what is a double ended guillotine break?
我们谈论的是，一个反应堆出现了破裂，在主系统的冷却系统，还有两端，闸床的破裂是什么？
The reactor vessel is surrounded by a thick steel-and-concrete primary containment vessel, equipped with a water reservoir designed to suppress overheating of the vessel.
反应堆由一个钢与混凝土构成的厚实外壳(第一层安全壳)保护着，另外还配有一个蓄水库，防止反应堆过热。
Reactor transients, rupture of the primary piping, steam line breaks, loss of flows and so forth.
反应堆瞬变，主管道的破裂，蒸汽线的断裂，流动的损失，等等。
The primary side, which is the reactor to the steam generator which are in the containment.
第一面，则是反应堆到蒸汽，发生器，那是在容器里面的。
The entire primary loop of the nuclear reactor - the pressure vessel, pipes, and pumps that contain the coolant (water) - are housed in the containment structure.
整个最初的核反应循环是这样的——高压管、管道、泵、冷却剂(水)——这些被安装在容器型建筑中。
Then you have the reactor vessel and piping which is the primary boundary which has an eight to ten inch thick reactor vessel and three to four inch thick steel piping to contain the cooling water.
你们会有反应堆糟和管道，它们是主边界，事故8到10英寸厚的反应堆槽，还有3到4英寸厚的钢管，那是用来装冷却水的。
With the primary containment vessel of reactor 1 still too full of steam, the radical decision was made to flood it with sea water to absorb the heat.
由于一号反应堆中最重要的密闭容器中充满了蒸气，因此临时决定用海水对其进行冷却，以便吸掉过多的热量。
Primary pulp sewage has been treated by intensified first level treatment reactor.
采用一级强化处理反应器处理原生纸浆造纸废水。
The control of catalyst bed temperature in a fixed bed reactor during high exothermic reactions is of primary concern to designers.
在强放热反应的固定床催化反应器的设计中，床层温度的控制常成为设计的主要焦点。
Reactor vessel cooling system is one of the important auxiliary systems in the primary system of China experimental fast reactor (CEFR), which can cool the reactor vessel in various conditions.
堆容器冷却系统是中国实验快堆(CEFR)一回路系统中的重要辅助系统之一，用于在各种工况下对反应堆堆容器进行冷却。
Both theoretical analysis and simulation prove that rationally designed leakage reactance of the primary winding can play a role of balancing reactor.
理论分析及仿真计算证明：地铁车辆辅助电源中变压器原边绕组的漏抗通过合理的设计，可以起到该平衡电抗器的作用。
Reactor primary Pump is the important equipment in the primary circuit, its working quality would directly influence the safety and operation of nuclear power plant.
核电站反应堆主泵是一回路的关键设备，其设备状态的优劣将直接影响核电站的安全和运行。
The reactor vessel constitutes the main part of pressure boundary of primary coolant.
反应堆压力壳构成了主冷却剂压力边界的主体。
Fault diagnosis of main pump of the primary system of reactor which runs at normal condition is studied by the vibration, analysis technique.
应用振动监测技术，通过参数分析、信号分析及谱分析，对反应堆一循环在役主泵的故障进行了分析诊断。
The design method of primary process pipeline and its notices were introduced in CCR reactor and generator frame area.
介绍了连续重整装置反再构架区主要工艺管道的设计方法、注意事项等。
The stopping behavior of the primary pump has been studied in the experiments and the reactor plant, however, the study on the stopping behavior of the primary helium circulator for HTR is very lack.
目前，对压水堆主泵的惰转特性已有大量的实验研究和实际运行结果，但有关主氦风机惰转特性的实验研究与理论研究还很缺乏。
The primary circuit is a close circuit that pressurize water whose function is to extract heat from the nuclear reactor.
主回路是一个对冷却剂加压的封闭回路。冷却剂的作用是带出反应堆内的热量。
The key problem of the loose parts monitoring system for primary loop of pressurized water reactor is how to extract loose parts impact signal from complex background noise.
压水堆一回路松动件状态监测系统的关键环节在于如何从复杂背景噪声中提取松动件冲击信号。
Heat produced by burning coke is used to continue the primary reaction as the hot catalyst is circulated back to the reactor and provides the heat of reaction for the cracking reaction.
燃烧的焦炭所产生的热量使主反应持续地进行，同时热的催化剂流通回到反应器并为之提供热量。
Both the primary helium circulator for high-temperature gas-cooled reactor (HTR) and the primary pump for the pressurized-water reactor are the key components in the reactor primary loop.
高温气冷堆主氦风机与压水堆主泵一样，均为反应堆一回路的关键设备。
Both the primary helium circulator for high-temperature gas-cooled reactor (HTR) and the primary pump for the pressurized-water reactor are the key components in the reactor primary loop.
高温气冷堆主氦风机与压水堆主泵一样，均为反应堆一回路的关键设备。
应用推荐