Students will power is sent to the control box, press ON / OFF button switch ON keys, operation indicator light, machine.
将电源送至控制箱内，按下ON/OFF按钮开关的ON键，运转指示灯指示，机。
It lets you press the power switch and the level meter will indicate the battery condition with power voltage for a few seconds.
资讯科技让你压电源开关，而且同高的公尺将会用力量电压指出电池情况数秒。
Press the "power switch" on front panel, can be step-by-step to switching the devices under controlled. Note: in this case, must be disabling the timer.
如果通过定时器来控制本机，请将本机电源开关打在“关”状态，受控设备会准时按顺序开启、关闭。
Operation: Once get power supply, loads and thermal resistors connected, press the power switch of temperature controller, and then it will start temperature control program automatically.
使用：接好电源、负载及热电阻线后，按下温控器电源开关，温控器即可自动投入定温控制运行。
Press the switch to turn off the power.
按电源开关封闭电源。谢谢。
This is done as follows: switch on the power, insert the plug, and then press the START button.
按照以下步骤进行：接通电源，插上插头，然后按“开始”键。
Press the red button (A2) to switch the instrument on. The instrument will power down 20 seconds after the last key has been pressed. All information stored, being retained.
按红色按钮(a2)将仪器启动，仪器将在20秒没有任何操作后关机。所有的信息将会被记录保留。
Plug in the included laptop-like power supply, connect laser and laser driver, activate the key switch and press the "on" button.
插上像笔记本一样的电源，连接激光器和激光器驱动，启动开关并按下“ON”按键。
Connected to power, press the voltage switch button, rotate adjustment handle clockwise slowly, and adjust the voltage to 20-30 Kilo volts.
接通电源后，按下高压开关按钮，顺时针慢慢转动调节手把，将电压调至2～3万伏。
Connected to power, press the voltage switch button, rotate adjustment handle clockwise slowly, and adjust the voltage to 20-30 Kilo volts.
接通电源后，按下高压开关按钮，顺时针慢慢转动调节手把，将电压调至2～3万伏。
应用推荐