When the pre-strain surpasses 0.95%, the reverse yield strength reaches to a constant.
当预应变超过0.95%时，反向屈服强度达到恒量。
In these experiments, specimens were bending to produce different pre-strain respectively, and then reverse bending were taken one by one.
在各弯曲试样得到不同的预应变后，又对其进行反向加载，记录不同预应变下各试样反向加载的弯矩随表面应变的变化曲线。
This paper Concentrates on the introduction of pre-strain materials, machine tool, calculation of extending value and extensive construction.
通过施工实例，介绍了预应力材料、机具伸长值计算及张拉施工。
The present paper discusses the effect of baking temperature, baking time and pre-strain on the bake hardenability of ultra low carbon bake hardening steel (ULC-BH steel).
研究分析烘烤温度、烘烤时间、预应变量等烘烤条件对超低碳烘烤硬化钢烘烤硬化性能的影响。
Cold deformation results in increasing of dislocation density and inhomogeneous dislocation distribution, the latter is the direct reason for pre-strain to promote microstructural evolution.
冷变形提高了钢中位错密度，也加剧了位错分布的不均匀性，后者是预应变加速组织演变的直接原因。
"Rio is still struggling with a calf strain," the manager told his pre-match press conference.
“费迪南德还是有点伤，”经理在赛前记者会上说。
The wear resistance of wheel steels is not affected by strain hardening under rolling/sliding conditions, while it is dominated by the pre-hardness of wheel steels.
滚滑条件下，车轮材料应变硬化程度的高低不影响车轮材料的抗磨损性能，试验前车轮材料初始硬度的高低是决定其抗磨损性能的主要因素。
Some rules of processing pre-punched hole setting are summarized through the simulated results of two instances and the analysis of stress and strain for sheets.
通过对两个例子模拟结果和板料应力应变的分析，总结出了工艺预冲孔设置的一些规律。
In the condition of eliminating the lagging strain of Angle iron, the magnitude of pre-stress putting on the Angle iron has litter impact on the ultimate bearing capacity of structure.
在消除角钢应变滞后的条件下，对角钢施加预应力的大小对结构最终承载力无明显影响。
Shake all ingredients except champagne with ice, then strain into an empty pre-chilled glass and top with chilled champagne before serving. Garnish with an edible flower.
除香槟外加冰摇合所有原料，滤入冰过的空杯子，注入适量冰冻过的香槟，饰以可食用的花。
The complete stress-strain curve of rock could be divided into pre-failure and post-failure regions according to the peak stress.
岩石的应力-应变全过程曲线以峰值应力为界，通常分为破坏前区和破坏后区两个部分。
The chemical composition, strength, cyclic stress and pre-cyclic-strain have a remarkable influence on the micro-plasticity behavior of the steels.
钢的化学成分、强度、服役应力和预应变处理显著影响其微塑性服役行为。
The modified removal method for measuring residual stress in thick pre-stretched aluminum plates is proposed and the stress-strain relation matrix is deduced by elasticity theory.
文中针对铝合金预拉伸厚板的特点，提出了测量其内部残余应力的方法，并运用弹性力学理论进行了理论推导，得到了应力-应变关系矩阵。
Low strain dynamic testing on actual pile was conducted to investigate if the wave velocity is varied in the installed pre-cast pile.
通过实际工程的低应变桩基动测，发现打入桩的波速随时间提高。
Results of displacement, stress and strain of the shaft under the common loads of bend and torsion are obtained by Pre-condition conjugate gradient method.
对该模型施加适当的约束和载荷，通过预前共轭梯度法，计算得到了轴类零件在常见工况-弯曲和扭转载荷作用下的位移、应力、应变等力学特性。
This paper introduces how to calculate the ultimate strength of external pre-stressed concrete beam with FRP tendons by means of strain reduction.
本文采用应变折减的方法推导了体外预应力FRP筋混凝土梁承载力的计算方法，并将计算结果与试验数据进行了对比。
As a rule, the state of working stress and strain of engineering structures and components can thought of as making additional deformation movement on referenced configuration with static pre-stress.
通常情况下，我们可以将工程结构或构件的工作应力和应变状态看为相对含静态初应力的参考位形作附加的变形运动。
When the axial static pre-stress is a constant, the impact compressive strength increases with an exponential function as the strain rate increases.
相同轴压下，冲击强度会随着应变率的增加而增加，呈现指数函数关系。
When the axial static pre-stress is a constant, the impact compressive strength increases with an exponential function as the strain rate increases.
相同轴压下，冲击强度会随着应变率的增加而增加，呈现指数函数关系。
应用推荐