The problems existing in stranding die, post-deformation device and sizing apparatus in producing wire rope are analyzed.
对生产钢丝绳用压线瓦、后变形器及定径装置在使用中存在的问题进行分析。
A new push_pull drawing technology is put forward according to the post drawing deformation of cylindric part. This technology is theoretically analyzed and evaluated in detail.
针对筒形件的后续拉深变形提出了一种新的推拉拉深工艺方法，并对此进行了较详细的理论分析和试验研究。
By use of precursory deformation information and post-seismic effect some earthquakes are analysed and the potential source zones in 3-5 years are pre-estimated.
利用地震前兆形变信息和震后效应进行了地震震例分析。并对3 ~5年内的潜在震源区进行了预估。
The post treatment can improve deformation and surface stress state, refine microstructure and increase hardness of cladding layer.
后热处理可改善变形和表面应力状态、细化组织、提高硬度。
The most pivotal technical problem of building high-speed railway on soft soil is strictly controlling post-construction settlement of subgrade and its elastic deformation of top surface.
在软土地基上修建高速铁路，其最关键的技术问题就是严格控制路基的工后沉降及列车高速运行时路基顶面的弹性变形。
At last the prediction of the lateral deformation induced by post-liquefaction in silt ground is done.
最后进行了粉土地基液化后侧向变形预测。
Deformation and moment of the concrete post have been changed due to bending vertically and horizontally during it was hoisted as a whole.
主要研究混凝土柱在纵横弯曲影响因素作用下所发生的变形及控制截面弯矩的变化，从而得出纵横弯曲对柱吊点位置的影响。
Deformation measurement and analysis system is the tool for post processing and analysis of the collected data.
变形观测处理系统是处理变形观测数据的有力工具。
Some of them have undergone very intense deformation in the post-eclogite stage, while others not.
这种榴辉岩有些经历过很强的后榴辉岩阶段变形作用，有些则没有。
Influences of the high temperature and high circle temperature on peak strength, post-peak characteristics, deformation characteristics are analyzed and compared systematically.
系统地分析比较了高温和循环高温作用对大理岩的刚度、峰值强度及变形特性等的影响。
This paper mainly discusses the issues of monitoring the verticalness central deformation and the turning round of Sichuan TV tower by post-processing static observation of GPS.
介绍了利用GPS静态观测事后处理分析的方法监测四川广播电视塔中心线的垂线度及塔身扭转的有关问题。
The sprayed workpieces go through such post-treating steps as baking at not to high temp for 30 min and natural cooling or water cooling, resulting in no deformation.
喷涂工件经不太高温度烘烤半小时，而后自然冷却或水冷，不会造成叶轮片变形；
The sprayed workpieces go through such post-treating steps as baking at not to high temp for 30 min and natural cooling or water cooling, resulting in no deformation.
喷涂工件经不太高温度烘烤半小时，而后自然冷却或水冷，不会造成叶轮片变形；
应用推荐