As shown in Figure 1-2, it can be thought of as a multiple position selector switch.
如图1 - 2所示，可认为它是一个多位置的选择开关。
Positive crimp depth is controlled by an 8 position selector knob conveniently located on the tool frame.
卷曲深度由8个可供选择的按钮(放在工具框)控制。
Each position of the selector must be clearly identifiable and must correspond to a single operating or control mode.
该选择器的每一位置必须能清晰识别，并且对应于单一操作或控制模式。
If necessary, set the carrier mode selector to the slow position.
若必要，将搭载车的模式选择设置为“低速”的位置。
If necessary, set the carrier mode selector to the slow position.
若必要，将搭载车的模式选择设置为“低速”的位置。
应用推荐