Also, try not to set them up for failure by going too long without food or spending more then a couple of hours sitting in a car or plane seat.
同时，避免外出过长而不给他们准备食物或者数小时时间一直坐在汽车或飞机的座位数，这会令孩子们产生挫败感。
The Mohr-Coulomb model is based on plotting Mohr's circle for states of stress at failure in the plane of the maximum and minimum principal stresses.
莫尔-库仑模式基于莫尔圆来判断最大和最小主应力平面上的破坏应力状态。
Therefore, it is further proved that local failure theory is correct and weak structural plane will control the stability of slope.
从而进一步证明了局部破坏理论的正确性和边坡软弱结构面是控制边坡稳定的关键因素。
Failure processes of sheet metals are modeled under plane strain tension.
在平面应变拉伸的情况下仿造了板形的失效过程。
Methods Based on the two failure mode of plane and wedge sliding destruction of the limit equilibrium theory, rock slope stability is analysed.
方法按极限平衡理论中的平面滑动破坏和楔体破坏两种破坏模式进行稳定性分析。
In addition, the generalized relationships between cyclic shear stress on failure plane and the number of cyclic loading causing liquefaction of the sandy soils are also presented.
此外，也给出了饱和砂土液化破坏时破坏面上循环剪应力与循环荷载次数间的一般关系。
Through the engineering practice, the bedding failure mechanisms of bedded rock side-slope could be divided into three types: plane rotatory sliding, disintegration sliding and gradual destruction.
通过工程实践，将层状岩体边坡顺层破坏机理归纳为三方面的问题，即：平面旋转滑动、解体滑动和渐进破坏。
Deformation will be concerted of the fourth weak interbed exceptant bank slope rock mass and weak interbed will be potential, the most dangerous failure plane.
第四层软弱夹层以外的岸坡岩体变形较协调，这一软弱夹层是岸坡潜在的最危险的破坏面；
Simultaneously, this method can provide references to the forecast of the shape and position of jointed slope failure plane and stability analysis of complex slopes.
同时，该方法对于预测节理边坡破坏面的形状与位置以及复杂边坡的稳定性分析都有一定的借鉴意义。
It is widely believed that Lin's plane ran out of fuel or that there was a sudden engine failure.
大多数非人为是因为燃料不足或者是引擎故障。
An example of reliability analysis of rock slope stability with plane failure is presented to demonstrate the validity and capability of the proposed SRSM.
以岩质边坡平面滑动破坏模式为例证明随机响应面法在边坡可靠度分析中的有效性。
In this study, the interface failure under the joint action of constant compression and periodical anti-plane shear were investigated.
本研究利用“剪切梁”模型，研究了在定常侧压力和周期性的反平面剪切载荷共同作用下，层间界面的破坏规律。
Shear strength of structural plane has an important influence on stability of engineering rock mass. It determines the probability of engineering rock mass failure.
结构面抗剪强度是影响工程岩体稳定的重要因素，它决定工程岩体破坏的可能性。
The model indicates that the failure of rock is a process in which there is a coupling between crack development and the slipping of cracked plane. The strain…
该强度模型表明介质破坏是一个过程，反映了强度突变的应变率阈值效应与侧限压力下主破裂面上矿物颗粒团局部二次破坏的力学机制。
Taking FMEA of fuel-metering system of jet plane engine as an example, failure infusing of functional role model, setting-up model of failure, and process of fault analysis was introduced.
并以飞机发动机燃料计量系统FMEA为例，阐述了功能角色模型的故障注入和故障模式的建立，以及故障分析过程。
The failure criterion can be judged by the rectangle region in the graph of the relation between ultimate out-of-plane load and ultimate in-plane shear.
它的破坏状态可以用极限面外荷载和极限面面内剪力关系图中围成的矩形区域来判断。
Large samples uniaxial compressive creep test indicates, the flow deformation and failure of SLATE is controlled by its structure plane.
大试件单轴蠕变实验表明，板岩流动变形破坏受结构面控制。
As to the shear strength mobilized in drained test, both of these two components are related with the effective normal stress on the failure plane.
而在排水试验中，则这两部分强度均对应于破坏时的有效应力。
Then, the influence of bottom hole pressure on the failure range of weak plane is analyzed for bore holes in naturally fractured formation, with the help of the local coordinate system.
通过建立局部坐标系，得到了裂缝性地层井壁发生失稳的弱面角度随井底压力变化的规律。
The failure modes of concrete covers were analyzed by use of the micro-plane theory.
应用微平面理论分析混凝土保护层的破坏模式。
Based on the plane stress full-elastic model and 3d numerical model, 2d and 3d methods of calculating the failure rotating speed of the composite flywheel were established.
分别基于平面应力型全弹性模型和三维数值模型建立了计算复合材料飞轮破坏转速的二维和三维算法。
In this study, the interface failure under the joint action of constant compression and periodical anti-plane shear is investigated.
本研究利用“剪切梁”模型，研究了在定常侧压力和周期性的反平面剪切载荷共同作用下，层间界面的破坏规律。
Before the failure of bamboo beams, cross-section strain distribution along the height was linear, and the plane-section assumption was established.
竹梁在破坏前，横截面应变沿高度方向的分布基本上呈线性，平截面假定是成立的。
The fretting fatigue behavior of TC4 alloy was investigated using cylinder-plane configuration. Based on the experimental results, the damage mechanism of fretting fatigue failure was discussed.
研究了TC4合金在柱面-平面接触条件下的微动疲劳行为，分析了其微动疲劳损伤机制。
The fretting fatigue behavior of TC4 alloy was investigated using cylinder-plane configuration. Based on the experimental results, the damage mechanism of fretting fatigue failure was discussed.
研究了TC4合金在柱面-平面接触条件下的微动疲劳行为，分析了其微动疲劳损伤机制。
应用推荐