At the second level , offset between two adjacent intersection was determined by the fuzzy phase controller;
第二级，用模糊相位控制器确定相邻两路口的相位差；
The composition of trajectory camera and working principle of the phase controller of revolution shutter are analyzed.
分析了弹道相机系统的构成，并对弹道相机的最主要部分——旋转快门相位控制器工作原理进行剖析。
The necessary shifts in signal phase are controlled via a dedicated beam steering controller or the architecture's central processor.
信号相位的必要相移通过专用波束调节控制器或集中安排的处理器进行控制。
In the first phase of the JSF lifecycle — restore view — a request comes through the FacesServlet controller.
在JSF生命周期的第一个阶段——恢复视图——中，会有一个来自FacesServlet控制器的请求。
Then, base on the problem of attitude control of a satellite under development, we design a NN compensation controller for high accuracy orientation phase.
然后，基于某型小卫星的姿态控制问题，设计了高精度定向阶段的神经网络补偿控制器。
Verify ac line voltage phase and frequency with the controller data plate on the enclosure door prior to connecting ac power.
在连接交流电源之前，请验证交流电压、相位和频率是否与控制装置外壳门参数板上的相应数据相同。
Zero phase error tracking controller was served as the feed-forward controller to improve the fast tracking performance of the system, thus exactly tracking of the system was implemented.
零相位误差跟踪控制器作为前馈跟踪控制器，提高了快速性，使系统实现准确跟踪。
This paper proposes a cascaded nonlinear PI controller for three-phase voltage source PWM rectifier, which is based on its model in synchronous reference frame.
该文以同步旋转坐标系模型为基础，设计了三相电压型PWM整流器的级联式非线性PI控制器。
The above interactive graphic shows pilot and air traffic controller interact during each phase of a typical commercial flight profile.
上图展示了飞行员与管制员在正常商业飞行的每一阶段相互配合的过程。
Parameters estimation method of controller based on the gain and phase margin is proposed.
给出了在希望的幅值和相角裕量下控制器参数的计算方法。
It is important to understand the phase characteristics of electro-acoustic device for the design and effect analysis of active noise cancellation controller.
了解电声器件的相位特性对有源消声控制器的设计及消声效果分析具有重要作用。
The Single-Phase 851 Digital SCR Power Controller from Spang Power Electronics offers the latest in Digital Signal Processing (DSP) technology and software.
单相电力电子控制器从斯潘851数字晶闸管电源提供软件的最新数字信号处理（DSP）技术和。
Type of fault, phase sequence, value of faulty current and breaking action time will be indicated on the intelligent controller promptly if breaker turns off because of faults.
断路器遇故障分断后，智能控制器能显示出故障类别、故障相序及故障电流值、分断动作时间值。
On the basis of the phase saturation, the fuzzy controller determines the next phase.
在通过检测线圈测得相位饱和度的基础上，利用第一级模糊控制器确定下一相位。
This paper presents a new way to measure the characteristic parameter of the phase shifting controller made of fiber with PZT by phase shifting.
提出了一种利用相移技术测定光纤PZT相移控制器相移特性参数的方法。
The Three-Phase 853 Digital SCR Power controller from Spang Power Electronics offers the latest in Digital Signal Processing (DSP) technology and software.
三相853数字晶闸管电力电子控制器从斯潘电源提供软件的最新数字信号处理(dsp)技术和。
The thermal sensor had a large lag phase, so the data got by the sensor of digital mass flow controller should be compensated in advance.
热式传感器有很大的滞后环节，在数字质量流量控制器中需要对传感器数据进行补偿。
The internal mode compensation controller is designed for the delay performance of TCP network system. The controller tuning method is presented based on the gain and phase margin.
本文针对TCP网络系统的时滞特性，设计基于内模补偿控制器，提出了基于幅值与相位稳定裕度的控制参数整定方法。
Using the non minimum phase system parameter model transformation of the model for the controller design.
采用了非最小相位系统参数模型转换为参数模型的控制器的设计。
Base on the feedback linearization theory for nonlinear systems, presenting a nonlinear model for three phase voltage source PWM and designing a nonlinear controller.
基于非线性系统反馈线性化理论，建立了三相电压型PWM整流器非线性模型，设计了一种非线性控制器。
A new tuning method for PID controller design is proposed as a class of stable and minimum phase plants.
该文为一类稳定的最小相位控制对象提出一种新的PID控制器的参数整定方法。
The difference of output voltage of inverter and 220v is set as control signal, controller change the PWM signal to regulate buck-boost converter and three-phase rectifier.
以逆变器输出的电压和220v的差值作为控制信号。设计控制器根据控制信号改变直流变换器和三相可控整流的PWM控制信号。
A repetitive controller can be obtained by designing a zero phase shift low pass filter. With the help of digital signal processing and software tools, it is easy to design a satisfactory controller.
该方法将控制器的设计转化为零相移低通数字滤波器的设计问题，借助于数字信号处理的理论和工具直接得到所需的控制器参数。
We can realize the automation of the phase modulation by programming the controller of stepper motor.
通过对步进电机控制器编程实现了相位调制的自动化。
The impulsive controller is designed to switch the in-phase synchronization state and the anti-phase synchronization state.
设计了脉冲控制器，实现了正反相同步间的动态切换。
The resulting controller is a finite impulse response (FIR) filter and hence problem of non-minimum phase zero cancellation is avoided.
这种控制器给出了避免非最小相位过程零极点对消的有限脉冲响应滤波器。
An unstable process is transformed into a minimum-phase system through mirror-injection, then solve the robust controller using closed loop gain shaping algorithm.
通过镜像映射将非稳定过程转换成最小相位系统，然后用闭环增益成形算法求解鲁棒控制器。
Turn on the power switch, then turn on the switches in controller. Check phase and voltage.
合上电梯供电开关，再分步控制柜内各控制回路电开关。检查所有电源电压和相序(相序继电器)是否正确。
Turn on the power switch, then turn on the switches in controller. Check phase and voltage.
合上电梯供电开关，再分步控制柜内各控制回路电开关。检查所有电源电压和相序(相序继电器)是否正确。
应用推荐