It is shown by the results that the model reflects moderately the dynamic process of electric charging and discharging of Pb-acid battery.
结果表明，此模型较好地反映了铅酸电池充放电动态过程。
Electric charging and discharging tests of Pb-acid battery are conducted and the experiments and emulation results are compared in order to verify the feasibility of the model.
为了验证模型的可行性，对铅酸电池进行了充放电实验，并对实验和仿真结果作了比较。
On the basis of analyzing the characteristics of electric charging and discharging of Pb-acid battery, the model of electric charging and discharging of Pb-acid battery is made.
在对铅酸电池充放电特性进行分析的基础上，给出了铅酸电池充放电模型。
The ultrasonic degradation of polybutadiene (PB) and block copolymerization of PB with acrylic acid(AA)in cyclohexane solution were studied.
研究了在超声波辐照作用下聚丁二烯（PB）在环已烷溶液中的降解及与丙烯酸（AA）的共疑反应。
The results showed that the detoxication of citrate acid to Pb and tartaric acid to Cd was comparatively distinct.
通过培养试验研究了有机酸对铅、镉的毒害影响，结果表明柠檬酸对铅，酒石酸对镉有较明显解毒作用。
Automotive lead acid batteries using low Sb positive grids and Pb ca negative grids sometimes suffer from the phenomena of premature capacity loss (PCL).
正板栅用低锑合金，负板栅用铅钙合金的汽车用铅酸蓄电池，有时会出现早期容量衰减现象。
Hot-process phosphoric acid contains a little impurities which are mainly Pb and very little Zn, Cu, Ni, Mn, Cr and Cd.
热法磷酸中含有少量重金属杂质，主要是铅以及微量的锌、铜、镍、锰、铬和镉等。
Pb-Sb and Pb-Ca alloys were generally used as the grid material for lead-acid batteries.
目前使用的铅蓄电池板栅合金主要是铅锑合金和铅钙合金。
The influence of structure design of Pb-plated reticulated SiC current collector on the plate design parameters and utilization efficiency of PAM of lead-acid batteries was studied.
研究了镀铅泡沫碳化矽集流体的结构对铅酸蓄电池极板的设计参数、正极活性物质利用率的影响。
The influence of structure design of Pb-plated reticulated SiC current collector on the plate design parameters and utilization efficiency of PAM of lead-acid batteries was studied.
研究了镀铅泡沫碳化矽集流体的结构对铅酸蓄电池极板的设计参数、正极活性物质利用率的影响。
应用推荐