• The result shows that breathing intensity, particle diameter and particle density are the three key factors influencing the deposition of inhalational particles.

    研究结果表明,呼吸强度、颗粒粒径以及颗粒密度是影响可吸入颗粒物沉积的关键因素。

    youdao

  • When the particle density is big enough, it is no longer the fractal aggregation.

    在粒子浓度较大时,一般聚集体呈密集结构,此时不具分形结构。

    youdao

  • In these mainly regions, the particle density of rock accords with normal distribution.

    这些主要区域的颗粒密度符合正态分布。

    youdao

  • The influence of non-uniform flow and particle density distribution on the simulation results was discussed.

    分析了流体的非稳态流动及颗粒的密度分布对模拟结果的影响。

    youdao

  • The nonlinear space charge effect due to the nonuniform particle density distribution in bunched beam of a linac is discussed.

    提出了在强流直线加速器中,由空间电荷束团的密度分布所引起的非线性效应。

    youdao

  • Then in part four, the quantities such as particle density, energy density at RHIC energy are calculated with these parameters' values.

    然后根据最佳参数值计算RHIC能量下粒子系统中各种粒子的粒密度、能密度和熵密度等。

    youdao

  • This paper explores the relation between dissolving quality and particle density of milk powder and obtains the special range of formula milk powder density.

    通过对配方奶粉冲调状态与颗粒密度关系的分析,确定了配方奶粉密度的特性值范围,从而简述生产过程中控制奶粉冲调性的要点。

    youdao

  • The bigger the particle diameter, the higher the particle density, and the faster the rotation speed of mold, then the longer the distance of particle movement will be.

    粒子直径越大、密度越大、转速越高,在同样时间内,粒子移动的距离越远。

    youdao

  • The experiment results show that the intensity of scattering will increase evidently with the increasing of particle size, particle density and relative refractive index.

    实验结果表明,随着粒子半径、粒子密度和相对折射率的增加,散射的强度将显著增加。

    youdao

  • With the increase of solids loading, the particle density increases and the bending strength of green body decreases for the network polymer accounting for only a small amount of the composition.

    随着固相体积分数的增加,单位面积的颗粒分布密度增大,网络高分子在成分中只占少量,坯体抗弯强度降低。

    youdao

  • With the increase of solids loading, the particle density increases and the bending strength of green body decreases for the network polymer accounting for only a small amount of the composition.

    随着固相体积分数的增加,单位面积的颗粒分布密度增大,网络高分子在成分中只占少量,坯体抗弯强度降低。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定