The results show that the error of estimated value of both throttle position sensor and manifold pressure sensor are less than 10%, and the strategy put forward in this paper is valid.
结果显示，大部分工况下进气压力传感器和节气门位置传感器的信号重构误差可控制在10%以内，表明了所提出的调节策略是切实有效的。
This paper analyzes the error of torque sensor of strain-resistor which derives from the influences of bending moment on elastic axis, and discusses the Eliminating techniques.
本文对在应用应变式扭矩传感器时由于在弹性轴上的弯矩而引起的误差进行了力学分析，并提出了消除的方法。
This paper gives the research and the analysis about the error source and the erasing method of error on the grating angle sensor.
就光栅角度传感器的误差来源以及消除误差的措施进行分析和研究。
In this paper, it is founded the error existed for a long time, which is caused by using the quadrant improperly to refer the trunnion-tilt sensor.
论证了长期以来存在的用象限仪标定炮耳轴倾斜传感器的方法误差。
In this paper, we have simplified the sensor as a finite length cylinder, and calculated the energy loss and the temperature error.
本文将传感头简化成有限长圆柱，计算出在微波场中传感头的能量损耗和温度变化。
A physical model of the active control of torsional wave is set up in this paper. Dinfluence of error sensor and secondary source on the optimal control results is studied.
建立扭转弹性波主动控制系统的物理模型，研究二次源、误差传感器位置对最优控制效果的影响。
So the analysis and compensation to sensor error, as well as the sensor data processing are done in this paper.
因此本文对传感器的误差进行分析和补偿，并对传感器的数据进行处理。
This paper introduces working principle of liner CCD remote sensor uniaxial turntable, analyses imaging error of turntable simulation flying and brings point and parameter design of turntable.
介绍了线阵CCD遥感器单轴转台的工作原理，分析了转台模拟飞行器成像的误差，给出了转台的指标及参数设计。
This paper introduces working principle of liner CCD remote sensor uniaxial turntable, analyses imaging error of turntable simulation flying and brings point and parameter design of turntable.
介绍了线阵CCD遥感器单轴转台的工作原理，分析了转台模拟飞行器成像的误差，给出了转台的指标及参数设计。
应用推荐