Fig. D: Moebius clock advances a single-sided paper loop with printed times.
图D：驱动印有时间刻度的单面纸带前进的莫必斯时钟。
On the stove, a piece of paper was stuck on the front of the clock, obscuring the face: "Ignore this clock.
一张字条贴在放在炉子的钟上，遮了钟面：不要看这钟，放在炉子上的钟老是不准。
This actually seems like a decent DIY project — it probably wouldn’t take much work to sync a paper shredder to your alarm clock.
这似乎是一个像样的DIY工程--也许往你的闹钟里同步装上一个碎纸机并不费力。
This actually seems like a decent DIY project - it probably wouldn't take much work to sync a paper shredder to your alarm clock.
这似乎是一个像样的DIY工程——也许往你的闹钟里同步装上一个碎纸机并不费力。
This paper introduces a method for intelligent clock design with 89c2051.
本文介绍了用89c 2051实现智能闹钟的设计方法。
The models studied in this paper include linear shift register sequences, feedforward sequences and clock controlled sequences.
本文研究的模型包括线性移位寄存器序列，前馈序列和钟控序列。
This paper is mainly a research on time consistence in Distributed Virtual Environment. Some clock synchronizations are introduced in it. Combined with practice, the result is proposed at last.
要做到时空一致，时间一致是关键，本文主要对分布式虚拟环境中时间一致性进行了研究，介绍了几种时间同步的方案，并结合实际应用，给出了实验的结论。
This paper mainly analyzes the application of the IBIS model in the system board design and system clock design for mobile computers.
本文主要分析了IBIS模型在移动微机板参设计和在系统时钟设计中的应用。
The paper introduces the design of digital clock based on FPGA and VHDL, the time of clock can be displayed with the digital driving circuit.
介绍了利用VHDL硬件描述语言结合FPGA可编程器件进行数字钟的设计，并通过数码管驱动电路动态显示计时结果。
This paper presented a type of timing clock LCD.
本文介绍了一种定时闹铃lcd。
According to the requirement of BTB's design, the paper adopts the symmetrical clock tree technique.
针对BTB的设计要求，确定采用树状网络分布的时钟分布技术。
Based on LFVC (Leap Forward Virtual Clock), this paper proposes a scheme named WLFVC, which is a fully distributed wireless scheduling scheme for WLAN (wireless LAN).
基于前跳虚时钟(LFVC)算法，本文提出了适用于无线以太网(WLAN)环境的全分布式的调度算法WLFVC。
The paper introduces the system design and operation principle of the primary reference clock equipment.
介绍了基准时钟的系统设计及工作原理。
A general purpose JTAG Boundary-Scan Clock Cell is designed in this paper.
本文设计了一种通用的边界扫描时钟单元。
This paper analyzed the means and principle of clock supply, and described the ways of timing transmission. At the same time, the advantages and disadvantages were also instructed.
分析了时钟提供的方式和原理，描述了定时传送的情况，并指出了它的优缺点。
This paper introduced the electronic clock back of the injection mold design process.
本论文介绍了电子钟后盖的注射模设计过程。
A new tool that can test the clock base frequency error of energy measuring devices and provide GPS standard time to calibrate real-time clock was introduced in this paper.
介绍了一种用来测量电能计量装置的时钟基频误差，并提供GPS标准时间以校准其实时时钟的新型工具。
In this paper, a detailed analysis of a phase interpolator for clock recovery is presented.
分析了应用于时钟恢复电路中的相位插值器。
This paper discusses the design and implementation of a low-power digital clock chip.
本文讨论了一种低功耗时钟芯片的设计与实现。
This paper gives an application of high OCXO and GPS synchronization clock in data-gathering.
本文给出了一种高精度恒温晶振（OCXO）和GPS同步时钟在数据采集中的应用。
This paper introduces the functions and work principles of serial clock chip DS1302, the design of interface circuit with AT89C51 single -chip microcomputer in the spray irrigation controller.
本文介绍了串行时钟芯片DS1302的功能和工作原理，并给出ds1302在灌溉控制器中与AT 89 C51单片机的接口电路设计。
In this paper, multi-function digital clock system design.
本文介绍了多功能数字钟的系统设计。
This paper presents a clock control circuit in which an electronic clock is made by a MCU AT89C2051 16-bit timer and real-time control is achieved by the electronic clock's function of precise timing.
提出的时钟控制电路，是利用单片机at89c 2051的16位定时器做成电子时钟，并利用电子时钟的精确定时作用实现了实时控制。
A method for subdividing the grating pulse signal by means of using computer clock pulse is presented in this paper.
本文介绍了一种利用计算机时钟脉冲细分光栅脉冲信号相位的方法——改进型时钟脉冲细分技术。
The power distribution system and the design of clock also included in this paper.
文章还对高速电路设计中电源层分配、时钟设计进行了讨论。
This paper discusses the application of clock representation in three phase transformer connections and other fields.
论述了“时钟表示法”在三相变压器联接组别和在其他方面的应用。
The theory of operation, design considerations, design, characters, main features of model ST0202 high performance digital clock are described in this paper.
本文介绍ST0202高性能数字钟的设计出发点、工作原理、设计特点和主要性能。
The paper introduces the principle of PLL clock synthesizer and the structure of MC12429, designs the circuit of the High Frequency clock synthesizer.
本文介绍了PLL合成时钟源的原理，介绍了MC 12429的结构，设计出了高频时钟源电路图。
This paper introduces the frequency deviations of NIM4 Cesium fountain clock , the method and result of a new evaluation.
详细介绍NIM4铯喷泉钟系统频移及其不确定度的最新评定方法和结果。
This paper introduces the frequency deviations of NIM4 Cesium fountain clock , the method and result of a new evaluation.
详细介绍NIM4铯喷泉钟系统频移及其不确定度的最新评定方法和结果。
应用推荐