It shows you the amount of packets as well as the packet transfer rate (see Listing 12).
它将向您显示数据包的数量，以及数据包的传输速率(请参见清单12)。
SCO links are symmetric: the master sends a SCO packet, then the slave sends a SCO packet in the following slot, so the data rate in each direction is the same.
SCO链路是对称的：主设备发出一个SCO数据包，然后在下一个时隙中从设备发出一个SCO数据包，因此每一个方向的数据率是一样的。
Guaranteed QoS includes three basic parameters: packet transfer delay, packet delay variation and packet loss rate.
有保证的服务品质包含三种参数：封包传输延迟、封包延迟变异，以及封包遗失率。
Quality of service Packet Scheduler. This component provides network traffic control, including rate-of-flow and prioritization services.
服务数据包计划程序的质量。这个组件提供网络流量控制，包括流动速度和排列优先顺序的服务。
However, performing classification quickly on multiple fields is known to be difficult, and the fast increase of packet arrival rate also put great pressure on the packet classification algorithms.
但是高速多维报文分类本身是一个公认的难以解决的问题，而且报文速率的快速增长给报文分类算法带来了巨大的压力。
It consists of three main elements: the congestion status control packet, the early congestion detection and the adaptive rate traffic conditioner.
该方案主要包括三个组成部分：拥塞状态控制分组、早期拥塞检测和流量控制算法。
In the paper, we propose a priority-based method which bases on the idea that the queue output rate decides the time of the output packet.
本文针对这一问题，采用队列出队速度决定队列出包时间的思想，设计了基于优先级的解决方法。
The link layer packet error rate and transmission delay are derived to evaluate this scheme.
推导了采用该方案时无线链路的误包率和包的传输时延的表达式。
The data transmission performance of Bluetooth is analyzed, including the packet Error Rate (per) and throughput of ACL data packet under the inter-piconet interference.
文中分析了蓝牙设备在微微网干扰下的数据传输情况，具体分析了ACL数据分组在微微网同频干扰下的丢包率及吞吐量。
Unlike other proposals, this mechanism takes the impact of wireless packet error ratio (per) on the packet size adjustment and performance of rate control into consideration.
与其他方案不同，该机制进一步考查了无线包错误率对包长调整和速率控制的影响。
Numerical results demonstrate ASR-ARQ can achieve much lower packet error rate with slightly longer delay and higher TCP throughput than the conventional scheme.
仿真结果表明，与传统方案相比，自适应选择重传方案在高误帧率环境下以较低的误包率、略大的传输时延获得了较高的TCP吞吐量。
Dynamic signals measured from experiment beams are first decomposed into wavelet packet components, then the wavelet energy rate index is computed and used to detect location of damage.
首先，将得到的结构响应信号进行小波包分解，然后通过小波包能量变化率指标来进行损伤定位。
Dynamic signals measured from experiment beams are first decomposed into wavelet packet components, then wavelet energy rate index is computed and used to detect location of damage.
首先将所得的结构响应信号进行小波包分解，然后通过小波包能量变化率指标进行损伤定位。
The performance comparison between VTBR and traditional position based routing protocols shows that VTBR algorithm has a much higher packet delivery success rate and a shorter average path length.
通过仿真，文中给出了VTBR算法与传统位置辅助路由协议的性能对比分析，对数据包传输成功率和平均路径长度这两个性能参数进行了评价。
The network could provide good quality of service (in packet loss rate and the packet transfer delay) and be compatible with a variety of services.
网络能提供较好的服务质量(包丢失率和包传输延迟)并兼容多种业务。
In a data communication system capable of variable rate transmission, high rate packet data transmission improves utilization of the forward link and decreases the transmission delay.
在一种可以用可变速率传输的数据通信系统中，高速率分组数据传输改进了正向链路的应用，并降低了传输延迟。
A consequence of this is that packet switched data has a poor bit rate in busy cells.
这的一结果是在忙碌的细胞中有贫穷的一点点率的被转变数据的那一个小包。
On the basis of the estimated packet arrival rate and the status of network congestion in router, the buffer was managed using rate-based random early detection(RED).
在路由器中根据网络拥塞状态和数据流到达速率，采用基于速率的随机早期检测机制进行缓存管理。
RBTCP is rate based, USES only end-to-end mechanism, performs rate control at the receiver, and USES inter-packet delays as the primary metric for rate control.
RBTCP是基于速率的，运用端到端的机制，以分组间的延迟作为主要的监控标准在接受端执行速率控制。
In wireless link, Packet loss may caused by the high channel bit error rate and nodes mobile, and multi-path routing and node switching will lead to reorder.
对于无线网络，信道的高误码率和节点移动等会导致丢包，多路径路由和节点移动切换等会导致乱序。
The unsaturated throughput is also analyzed using this model. And we can get the relationship between the packet arrival rate and the throughput.
针对此模型本文还对分组到达为非饱和的情况下的吞吐量进行了分析，并得出吞吐量和分组到达率之间的关系。
At least one pilot channel output provides a basis to determine an estimated packet error rate.
至少一个导频信道输出提供确定估计分组差错率的基础。
Simulations results show that the method can efficiently save rebroadcast rate of packet to transmit and broadcast latency time in the case of guaranteeing broadcast success rate.
仿真结果表明，在保证广播成功率的情况下，该方法可以有效地节省重播包比率和广播等待时间。
The simulation on NS2 shows that the average throughput is improved, and the packet loss rate is decreased. With the JRED algorithm, the stableness and reliability of network are enhanced.
利用NS 2对改进的算法进行仿真，结果表明，JRED算法提高了平均吞吐量，降低了丢包概率，增强了网络稳定性和可靠性。
It is mainly exhibited as in the high bandwidth network environment, the current protocol algorithms can't guarantee nicer service quality of low packet loss rate, RTT and dithering of RTT.
主要表现为在高速网络环境下，现有的协议算法不能保证低的包丢失率和低的时延及时延抖动等服务质量需求。
At the same time, the protocol should be designed to minimize the system packet loss rate, packet loss rate is an important measurement of the communication protocol.
同时，协议设计应尽量降低系统丢包率，丢包率将是衡量该协议好坏的重要指标。
Therefore, the proposed receiver is able to reduce packet miss rate and false alarm rate while robust to a severe channel condition, and achieve fast and accurate signal quality detection.
本发明的接收器能在恶劣的信道条件下降低数据包错过率和错误报警率，而且可达到快速与准确的信号质量检测的目的。
Experimental results show the scheme has high energy efficiency, meanwhile, drops the packet error rate effectively.
实验结果表明，该方案具有较高的能量效率，能够有效降低误包率。
Experimental results show the scheme has high energy efficiency, meanwhile, drops the packet error rate effectively.
实验结果表明，该方案具有较高的能量效率，能够有效降低误包率。
应用推荐