Figure 1 shows a typical single-supply amplifier's output swing as you drive the output to the rails.
图1显示了驱动轨输出时，典型单电源放大器的输出摆幅。
The output swing and linearity range of the ROIC were compared, using different combinations of the CDS switch and SF structure.
本文比较了在不同的采样开关管和源随器组合方式下，电路的输出摆幅和线性范围的变化。
The output swing can be improved efficiently with push-pull class-AB output stage, thus high-drive capability with low power supply is obtained.
输出级采用推挽式AB类结构，能有效地提高输出电压的摆幅，从而得到电路在低电源电压下的高驱动能力。
The replica-amplifier gain enhancement technique is applied to improve the DC gain of the amplifier, which does not degrade the output swing and is very suitable for low-voltage applications.
为了提高运放的直流增益，采用了复制运放增益增强技术，这种技术的特点是在提高增益的同时不影响输出摆幅，非常适合低电压场合。
The wall display can also provide captions for display-over images and Swing components, allowing for a form of closed captioning (for example, to display any spoken speech output).
墙壁显示还可以提供所显示图像的字幕和Swing组件，以显示关闭字幕的窗体(例如，显示任何播放的语音输出)。
Output stage is a class AB to obtain the output high swing.
输出级采用了AB类推挽输出以获得高的输出摆幅。
When designing output stage, in order to enhance the efficiency, it uses the push-pull common source stage amplifier as the output stage, the output voltage swing basically reached rail-to-rail.
在输出级设计时，为了提高效率，采用了推挽共源级放大器作为输出级，输出电压摆幅基本上达到了轨至轨；
The output of the detector is the video - signal proper, with a 2 - volt swing.
检波器的输出是相应的视频信号、摆幅为2伏。
Used the switched capacitor Common Mode Feedback circuit(CMFB) in main amplifier to achieve a large output voltage swing and decrease the static power consumption at the same time.
主放大器采用开关电容共模反馈电路在获得大输出摆幅的同时降低了功耗。
The output signals are full swing voltage.
且输出为全摆幅电压。
The amplifier employs fully differential structure to obtain high output voltage swing, and uses source degeneration techniques to improve the linearity.
该放大器采用全差分结构以获得高输出摆幅，利用源反馈技术改善线性度，并设计了共模反馈电路以稳定共模输出电压。
Based on traditional two-stage amplifier, cross-coupled class AB output stage and cascode compensation were adopted to improve output voltage swing and bandwidth.
在传统两级运放的基础上，采用交叉耦合的AB类输出级和共源共栅补偿，提高了输出摆幅和带宽，并通过数学工具对功耗进行了优化。
This resistor significantly reduces current-output capability and the output-voltage swing with low-resistance loads.
电阻显著减小了输出电流能力和电压输出随低电阻负载的波动。
For example, choosing the negative rail as the ground reference may optimize the dynamic range of an op amp whose OUTPUT is designed to swing to 0v.
例如，选择负轨作为地参考也许能够优化一个输出可以至0运放的动态范围。
The swing motor comprises a swing motor shaft core, a left end cover, a stator, a rotor, a vane, a right end cover, an output flange, a sensor and a conical roller bearing;
它包括摆动马达轴芯、左端盖、定子、转子、叶片、右端盖、输出法兰、传感器和圆锥滚子轴承；
Output shaft when the swing set in the center of rotation on the trip-down, design may also need to set rotation angles and movements itinerary.
出力轴在间歇分度时，可设定在旋转行程的中心点上停动，也可设定旋转角度和升高能力。
Output shaft when the swing set in the center of rotation on the trip-down, design may also need to set rotation angles and movements itinerary.
出力轴在间歇分度时，可设定在旋转行程的中心点上停动，也可设定旋转角度和升高能力。
应用推荐