Using the input and output signal, the method can model the system, and can control the dynamical property of the system with the inverse transfer function of the controlled object as the controller.
本方法以实际系统的输入输出信号为依据，实现系统建模，用被控对象传递函数的逆作为串联控制器来对系统的动态特性进行控制。
Through instrumental variable identification method, the single input single output difference equations and the Z transfer function were gotten.
采用辅助变量辨识方法辨识得到单输入单输出差分方程和Z传递函数。
In transfer function models these equations are transformed and variables are eliminated between them to find the relation between selected input and output variables.
在传递函数模型中，这些方程经过（拉氏）变换，并消去中间变量，以求得所选定的输入输出变量间的关系。
It is proposed that LCR output filter can decrease the peak value of the gain of voltage transfer function as well as the high frequency burr contained in the source current.
并且提出采用LCR输出滤波器来减小电压传递函数增益的峰值，从而在串联电感较小时能够同时减小电网电流中高频毛刺的含量。
In this paper, multiple output error feedbacks are introduced via the parallel decomposition of the plant transfer function in the internal model control system.
本文通过对被控对象模型的传递函数并行结构分解，引入多重输出误差反馈，并根据内模结构来设计系统控制器。
The influences of feedback resistance on the output waveform and transfer function of PIregulator are analyzed in this paper.
本文分析了反馈电阻对PI调节器的输出波形及传递函数的影响。
In succession deduct correlative transfer function and bode diagram of stress control's linear dynamical system (constant pressure output control system).
推导出应力控制时的线性动态系统(恒压输出控制系统)的相关传递函数和伯德图。
This method can identify the transfer function of the system only using SOS, by sampling multiple outputs or oversampling a single output.
这一算法通过单输出的过采样或者多输出的采样，能够仅仅利用输出的SOS信息辨识出系统传输函数。
Transfer function model reduced error of forecast due to it made use of ARIMA model theory as well as calculated affection of input series leading the predicted value of output series.
由于传递函数模型是在利用ARIMA模型理论基础上，同时将输入序列的变化对输出序列预测值的影响充分的加以考虑，所以可以使预报误差大大降低。
The pulse transfer function matrix of linear discrete-time multivariable systems is often non-diagonal. This shows that there is coupling between the input and output of systems.
线性离散时间多变量系统的脉冲传递矩阵往往不是对角线形的矩阵，这表明系统的输入输出存在耦合。
Even slight mismatching will cause large errors in the transfer function and degrade the output impedance causing the circuit to become less of a true current source.
即使是轻微的错配会造成较大的误差在传递函数和降解输出阻抗造成电路成为少一个真正的电流源。
A system was set up to test the modulation transfer function (MTF) of a photoelectric simulation system. The method used the ratio of magnitude of the output image to the input image.
建立了某光电仿真系统的调制传递函数(MTF)评测系统，系统采用频谱对比法测试了仿真系统的MTF。
The particularity of the filter which connected with VFD's output is pointed out through analyses of its transfer function.
对变频器之后滤波器的传递函数进行了分析，指出了它的特殊性。
In the simplest case, these products are simply summed, fed through a transfer function to generate a result, and then output.
在最简情况中，对这些乘积只进行简单的相加求和，然后馈入传函生成结果，既而输出。
The paper gives realization second-order OTA-C filter circuit structural and current transfer function of filter by researching the transmission property of multi-output CMOS trans-condutor.
通过对多输出的CMOS跨导器传输特性的研究，给出了实现二阶OTA—C滤波器的电路结构和电流传递函数。
The paper gives realization second-order OTA-C filter circuit structural and current transfer function of filter by researching the transmission property of multi-output CMOS trans-condutor.
通过对多输出的CMOS跨导器传输特性的研究，给出了实现二阶OTA—C滤波器的电路结构和电流传递函数。
应用推荐