The optimal hydraulic design can effectively improve the outlet flow pattern of suction box to ensure better flow conditions for pump and raise the efficiency of pumping system substantially.
进水流道水力设计优化可有效地改善进水流道出口流态,确保水泵有良好的进水条件,大幅度提高水泵装置效率。
Some vehicles have a filter in the outlet side of the pump.
有些汽车的滤清器安装于燃油泵的出口。
Fill oil into the oil tank, when the hydraulic pump is full of oil fluid, manually turn the coupling, till there is no bubble in the oil outlet.
向油箱灌油,当油液充满液压泵后,用手转动联轴节,直至泵的出油口出油并不见气泡时为止。
The level of suction pumps for the axial direction, pump discharge outlet may be fitted into the needed horizontal or vertical direction.
泵吸入口为轴向水平方向,泵排出口可根据需要装成水平或垂直方向。
High viscosity of the pump outlet pipe also shall set up relief valve or other protective device on the road, so that once the clogging pump export channels, can open the relief valve pressure relief.
高粘度泵的出口管路上还应当设置安全阀等保护装置,这样一旦泵的出口通道发生堵塞,就可以打开安全阀卸压。
For ventilation of pumps the valve should be mounted adjacent to the pump outlet.
对于泵通风阀应安装毗邻泵出口。
Screw pump is a kind of rotary pump, when the outlet end is blocked, the pressure will gradually increase, so that more than a predetermined pressure value.
螺杆泵是一种容积式回转泵,当出口端受阻以后,压力会逐渐升高,以至于超过预定的压力值。
During maintenance, it is not permitted to change the original position between the inlet and outlet on the common rail pipe and connection from pipe and pump at random.
维修过程中,要注意不要随便改变原来共轨管上的进、出油口位置以及与喷油泵出油口之间的连接关系。
Germany HYDAC high pressure pipeline filter of pump outlet ensures hydraulic oil system cleanness, and upgrade machine reliability.
液压油泵出口配置德国HYDAC高压管路滤油器,确保液压系统的清洁度,提升机器的可靠性。
It is also discovered that the axial velocity distribution and velocity-weighted average swirl Angle at the outlet section of axial-flow pump vary with the changing of wall roughness.
研究还发现,水泵出口断面轴向流速分布均匀度和速度加权平均偏流角也随壁面粗糙度改变而改变。
They pass solid up to 90% of pump outlet diameter.
他可以通过泵出口直径90%的颗粒。
The influence of outlet circulation of mixed-flow pump on the hydraulic performance of the outlet pipe was studied in this dissertation.
本文主要研究混流泵出口环量对泵出水管道水力特性的影响。
Circulating water pump inlet pipe and outlet pipe should also install pressure gauge.
循环水泵的进水管和出水管上也应装压力表。
The test results have proved that the flow rate widely varied and the pump efficiency is high when the pump outlet line structure was altered and the outlet pressure was controlled in a special limit.
试验结果表明,改变泵出口管线结构,使泵出口压力在一定范围内工作时,流量变化大,而且泵效率较高,可以作为泵调整参数的一种手段;
Each fluid enters through its own pump inlet and outlet.
各种流体进入其自己的泵入口和出口。
A typical fuel-supply system consists of a fuel tank assembly, fuel lines, or fuel pump, and outlet filter. The fuel tank stores a supply of fuel.
典型的燃料供给系统由油箱总成、油管、燃油泵和汽油滤清器组成。油箱用于存储汽油。
Both water inlet and outlet pipelines should be supported by a separate stand and not by the pump body.
进出水管路应另设支架支撑,不得籍泵本体支撑。
Mating portions on the frame and tank (140) guide engagement of a tank outlet with a pump inlet tube.
框架和贮罐(140)上的配合部分导引贮罐出口与泵入口管接合。
Pump inlet and outlet are on the same horizontal axis and of the same diameters, thus allowing easy disassembly and small occupation space.
泵进、出口在同一水平轴线上,且口径规格相同,装卸极为方便,占地面积小。
The pump body and pump cover composes the pump studio. The inlet of the pump body is horizontally while the outlet is straight-up.
泵体和泵盖构成泵的工作室,泵体的入口为水平方向,出口垂直向上。
In order to avoid screw pump is damaged, usually installed in the screw pump bypass relief valve outlet to a stable outlet pressure, keep the pump running.
为了避免螺杆泵损坏,一般会在螺杆泵出口处安装旁通溢流阀,用以稳定出口压力,保持泵的正常运转。
Up to 10 outlet flows from a single pump. Simplified synchronous actuator movement.
单一流动泵,具有多达10个出水口。简化的同步运转。
Starting from the outlet of the pump, the water runs through the upstream tank (on the Kaplan side), the model, the downstream tank and back to the inlet of the pump.
从泵的出口,水流通过上游水箱(在轴流式水轮机这边)、模型机、下游水箱返回泵的进口。
The direction of rotation of the pump with high viscosity, oil outlet in accord.
高粘度泵的旋转方向要与进、出油口相符。
The catalyst pretreatment method ensures that the outlet pressure of the catalyst feed pump is remarkably lower, and catalyst feed is stable without blocking.
采用本发明的催化剂的预处理方法使得催化剂进料泵出口压力明显偏低,催化剂进料稳定,无堵塞。
The two channels near the outlet of the pump have obvious gas accumulation with higher gas voids.
靠近泵出口的两个叶道内,有气相的积聚,含气率较高。
The obtained pressure signal of pump outlet is analyzed with fractal dimension.
对采集的液压泵信号进行了分维数分析。
Stop the pump, close the column outlet and remove the packing reservoir. This is most easily done by first removing the column from the stand and then unscrewing the reservoir over a sink.
停止泵压,关闭柱的出口,去除填压用的贮液器。首先从试管架上卸下柱体,然后从槽上拧下贮液器,这样就很容易完成。
Stop the pump, close the column outlet and remove the packing reservoir. This is most easily done by first removing the column from the stand and then unscrewing the reservoir over a sink.
停止泵压,关闭柱的出口,去除填压用的贮液器。首先从试管架上卸下柱体,然后从槽上拧下贮液器,这样就很容易完成。
应用推荐