Air cooling process will have a lot of water (oil) condensation out, after the separator is isolated.
空气冷却过程将有大量的水(油)蒸气凝结出来，经过分离器使之分离出来。
The reference value of structural design of height adjustment supporting device of the cooling water tank is pointed out.
本冷却水槽中高度调节支撑架装置的结构设计具有参考价值。
As alkalies in the coal dust ash dissolve out and carbonates are entrained into the system, serious scaling occurs in the cooling water system of the dust collector.
由于粉煤灰中碱性物的溶出及碳酸盐带入系统，导致除尘冷却水系统存在严重的结垢问题。
The water distribution device is an important part of the Passive Containment Cooling System (PCCS), which is a key to carry out the function of the PCCS.
非能动安全壳冷却系统(PCCS)水分配装置是PCCS的重要组成部分，也是系统功能能否实现的关键。
This article deals with the application, property and cooling mechanism of PAG polymer quenchants. It is pointed out that its cooling mechanism is quite different from the mechanisms of oil and water.
本文介绍了PAG类淬火液的应用范围、物理性能及冷却机制，指出它的冷却机制与水、油的冷却机制完全不同。
This paper puts out the method to decide the optimization period of cleaning of water-cooling sets based on the largest average of COP, which was applied in industry practice.
根据水冷设备机组运行曲线，提出以最大平均COP来确定其最佳清洗周期的方法，并将其应用于实际中。
The qualitative analysis to 1000MW air cooling unit is also carried out for owners reference in determining the configuration mode of feed water pump.
同时对1000MW级空冷机组进行定性分析，供业主在决定给水泵配置方式时参考。
Ultra filtration and reverse osmosis processes were carried out to treat circulating cooling sewage. The treated water quality accords with the make-up water of the lower-pressure boiler.
采用超滤、反渗透的工艺处理电厂循环冷却排污水，处理后的水能够满足低压锅炉补充水的要求。
Aiming at the need of checking cooling water leakage which leaks out into the gas engine cylinder, a new intelligent device is developed.
针对机务段检测柴油机气缸冷却水内漏的需要设计开发了一种新型智能检测仪器。
Points out that the cubic law of pump power is not valid for the cooling water system of central air conditioning for it is an open system. The static head should be the lift in a cooling tower.
指出集中空调冷却水系统为开式系统，一般不适用功率三次方定律，静压头应为冷却塔塔体扬程，并提出了冷却水泵变速时轴功率的计算公式；
The modeling of cold end system was carried out surrounded by its four subsystems, which are condenser, cooling tower, the end of lower pressure cylinder, and circulating water pump.
冷端系统的建模主要围绕其四个子系统展开，即凝汽器、冷却塔、汽轮机低压缸末端以及循环水泵。
The modeling of cold end system was carried out surrounded by its four subsystems, which are condenser, cooling tower, the end of lower pressure cylinder, and circulating water pump.
冷端系统的建模主要围绕其四个子系统展开，即凝汽器、冷却塔、汽轮机低压缸末端以及循环水泵。
应用推荐