The feed-water from the condenser coming down the vessel and out through to the core.
这个从压缩机的补水，从管子往下,流出，进入核心。
According to the conditions of process and requirements of equipment structure as well as present standard and criterion, this chlorine condenser is worked out.
本文根据工艺条件及设备结构要求，按照现行的标准、规范，设计了这台氯冷凝器。
On the base of both consideration of heat transfer performance and resistance, the optimization and research are carried out on single spiral duct double pipe condenser.
本文在综合考虑传热性能和摩擦阻力等因素的基础上，对单螺旋槽套管式冷凝器的结构进行了优化和研究。
The steam exhaust from the condenser can then be fed into the main stack on the boiler giving it that classic look – steam out of the main stack however it can be fed into any stack.
从压缩机从排出的蒸汽然后可以进入锅炉的主烟囱，赋予它经典的形象——蒸汽从主烟囱中出来。但其实蒸汽可以流入任意一个烟囱。
Taking fan blade out of condenser.
将扇叶由冷凝器中取出。
Macroscopic and microscopic analyses of a damaged condenser pipe were carried out to investigate the leakage failure of a DUNHAM-BUSH condenser.
针对DUNHAM BUSH冷水机组冷凝器的泄漏问题，开展了失效冷凝器铜管的宏观和微观分析。
Starting with the heat balance of steam turbine unit and condenser, the study is carried out on changed direction of exhaust steam point after turbine performance aging.
从汽轮机组和凝汽器的热平衡入手，对汽轮机性能老化后低压缸排汽点变动方向进行了研究。
Eddy current detection for new copper tubing should be carried out before the replacement of copper tubing of condenser and oil cooler in thermal power plant.
火力发电厂凝结器、冷油器铜管更换前要对新铜管进行涡流检测，根据多年的检测经验，介绍在火力发电厂铜管涡流检测中的一点经。
Angle distortion modeling and prediction with computer for heavy plate multi-pass welding are carried out during condenser fabrication for nuclear power station.
对核电凝汽器制造中的大拼板多层焊后的角变形进行了计算机预测。
Based on the test results and the practical engineering, the calculate mode of the air-cooled condenser structure system and the original design methods about the joint are pointed out.
基于试验数据并结合实际工程，提出了空间钢桁架结构内力计算模型，及有关节点域设计的初步建议。
The modeling of cold end system was carried out surrounded by its four subsystems, which are condenser, cooling tower, the end of lower pressure cylinder, and circulating water pump.
冷端系统的建模主要围绕其四个子系统展开，即凝汽器、冷却塔、汽轮机低压缸末端以及循环水泵。
The modeling of cold end system was carried out surrounded by its four subsystems, which are condenser, cooling tower, the end of lower pressure cylinder, and circulating water pump.
冷端系统的建模主要围绕其四个子系统展开，即凝汽器、冷却塔、汽轮机低压缸末端以及循环水泵。
应用推荐