The optimum quantity of the spirulina, Aspaartame, ASK and xanthan gum were determined.
确定了螺旋藻粉、蛋白糖、安赛蜜、黄原胶的最佳添加量。
It shows that the optimum quantity of ODF additive is 6%, the cake made so has good flavor, color, texture and the taste almost the same as that of control.
结果表明，当燕麦膳食纤维添加量为6%时，生产出的蛋糕色、香、味和组织结构都比较理想。
According to the influences of different fillers and different matrix to the waste composite material, we could decide the best filler and the optimum quantity.
通过研究不同填料及不同基体对废弃物复合材料性能的影响，确定最佳的填料种类及最佳添加量。
When producing the rare earths Fe-Cr-Al alloy by electroslag remelting method, the optimum quantity of rare earths added to three phase lining electroslag furnace is 0.5%.
电渣双联法生产稀土铁铬铝合金时，稀土在三相有衬电渣炉中的最佳加入量为0.5%。
Thi paper gives a few inequality of optimum ordering quantity (or optimum storage) when demand and storage take discrete value.
本文给出了需求量与存储量取离散值时的最佳订货量(或最佳存储量)的若干不等式。
The optimum combination between electric current density and input quantity is put forward.
提出了存在着电流密度与进料量的最佳组合。
The optimum UV varnishing oil quantity in full format UV coating on coated paper used in textbook cover was studied.
研究了用铜版纸印刷的中小学课本封面进行UV上光时，上光油的最佳用量。
The type and quantity of adding agents have been studied, and the optimum composition and technological condition have been selected.
对所需添加剂的品种及用量进行了研究，选出了最佳配方及工艺条件。
Study on optimum plugging quantity proves that the more plugging agent used, the more complete plugging of high permeable formations, and thus higher sweep efficiency and recovery.
从最佳封堵用量研究得出：堵剂用量越大，高渗带封堵得越彻底，因此波及系数越大，原油采收率越高。
We could derive the supplier's optimum price and the consumer's optimum ordering quantity through separately establishing the profit function models of both sides of the supply and demand.
通过分别建立供需双方的利润函数模型并导出供方的最优定价和需方的最优订货量。
The function of binary quadric fertilizer effect has been extensively used in China to determine the optimum economy fertilizing quantity.
针对目前国内利用二元二次肥料效应函数确定最佳经济施肥量的数学方法存在的问题。
Such a structural optimum design based on the reliability can increase the design quantity and obtain obvious economic benefit, that is to say, the structure is both safe and economical.
这种基于可靠性的结构优化设计可明显地提高复合材料结构的设计质量，使得复合材料结构既安全可靠又经济合理。
The suitable proportion and quantity of inoculation, the optimum nitrogen source and its ratio in the medium were established through mixed fermentation.
利用微生物混合发酵确定了发酵菌种的接种比例、接种量、最佳氮源及其添加量；
The effect of temperature, time, the quantity of the initiator and MMA on the copolymerization reaction is studied. The optimum reaction condition and formulation are acquired.
研究了反应温度、反应时间、引发剂的用量及第一单体MMA的用量对接枝共聚反应的影响，确定了最佳的反应条件和配方组成。
The optimum mixing quantity of cement, water-solid ratio and quantity of additives of cement-soil slurry satisfying the space-filling effects are put forward after this research.
试验研究表明：土源、水泥掺量和掺水量是影响水泥土浆特性的最主要因素。
Determining the quantity of starch, bone mire of chicken and soybean protein which had affection on the quality of sausage by single factor experiment, we could acquire the optimum additive scope.
通过单因素试验确定淀粉、鹅骨泥、大豆蛋白等添加量对红肠品质的影响并确定最佳添加范围。
It can not only completely eliminate common computed errors, but also make its calculation result an optimum solution of the air quantity regulation through increasing resistance.
修改后的程序不仅可以完全消除计算错误，而且可使风网解算结果成为风网增阻调节的一个最优解。
The optimum additonal quantity should be on the basis of the specific case.
其最佳加入量要视具体情况而定。
The fermenting conditions such as initial PH, volume, inoculability quantity etc. were studied, and the optimum conditions have been found.
发酵条件考察初始pH、装液量、接种量等方面，确定了最适发酵条件。
The optimum inoculation quantity of scale-up culture is 15% comprehensively considering the biogas production time, the maximum biogas production level, and the total production level of methane.
综合考虑甲烷产生的时间、最高含量和总产甲烷量，放大培养的适宜接种量范围为15%。
Based upon experiments, optimum scooping speeds are proposed for various kinds of materials in order to minimize the necessary work to be done to scoop up a unit quantity of material.
为使挖取单位物料所需的功为最小值，通过试验提出了对不同物料的合理挖取速度。
To ensure the quantity of collected joint samples enough, and at the same time, to save surveying workload, the optimum scan line length should be determined first of all.
为了保证采集的结构面样本数量足够多，同时又使测量工作量最省，测线法应用时首先需要确定一个能够保证测量精度的最小测线长度——最佳测线长度。
To ensure the quantity of collected joint samples enough, and at the same time, to save surveying workload, the optimum scan line length should be determined first of all.
为了保证采集的结构面样本数量足够多，同时又使测量工作量最省，测线法应用时首先需要确定一个能够保证测量精度的最小测线长度——最佳测线长度。
应用推荐