So, under thermo economic optimization condition, the air-source heat pump can achieve the most economical interest.
由此可见，热经济学优化可以使风冷热泵系统获得最好的经济性。
The algorithm and its convergence, optimization condition, some suggestions about the computation, and the examples are given.
文中给出了算法及收敛性、最优性条件、计算实施的若干建议，以及计算实例。
The research of optimization condition on determination of chromium content in dairy products by graphite furnace atom absorption spectrographic methods was mainly developed.
本文主要开展了石墨炉原子吸收光谱法测定乳品中铬含量优化条件的研究。
The energy consumption at stand-by state can be reduced by 21% after the optimization of the switchover condition.
最后对电源状态的转换条件进行了优化，优化处理后待机态的能耗节省了21%。
The optimization results are analyzed in the single condition and multiple conditions versus the changes of some parameters.
并对优化过程中的部分参数做了改变，分析了在分立条件下与综合条件下的优化结果的差异。
To minimize the thermal noise ENF under the buoyant condition of the cable, the optimization of the antenna parameters is obtained.
为了获得最小热噪声ENF ，在电缆浮力条件下对天线参数进行了最优化。
By recognition of work condition, off-line identification and on-line optimization of parameters, hybrid model can be used to simulate dynamics of complex process correctly in a large scale.
通过工况的识别以及模型参数的离线辨识和在线优化，混合模型可以准确地模拟复杂过程在大范围内的动态特性。
Optimization of computer networks is a multi-restrain condition nonlinear 0-1 problem.
计算机网络优化是一个多约束条件的非线性0— 1问题。
The optimization process condition is researched by the method of simulation, and bring up the usage scope of this method.
并用模拟法进行了部分氧化工艺优化条件的研究，提出了这一方法的使用范围。
Methods: The best instrument condition was determined with optimization and compromise method.
方法运用优化和折中的方法，确定最佳的仪器条件。
Methods Basing on the condition of optimization experiment adopted direct assay with ammonia iminohydrolase.
方法根据测定条件的优化实验采用肌氨酸氧化酶法直接测定。
On the basis of them, three optimization algorithms for minimum condition evaluation are introduced.
在此基础上介绍了最小条件评定的三种最优化算法。
Then, it took marginal analytical method and utter citing method to evaluate optimization in the condition of calculating reliability.
然后分别采用边际分析法及穷举法，确定不考虑及考虑可靠性条件的最优化。
Container loading is the three-dimensional problem in "cutting and packing" problems. It is combined optimization with complex constraint condition.
集装箱装入问题是“切割和装入”问题领域中的三维空间问题，是具有复杂约束条件的组合优化问题。
The system uses the simulated annealing algorithm and the polygon algorithm in parallel condition to optimization design for arch dam.
采用并行环境下的模拟退火算法和复形法对拱坝进行体形优化设计。
This article gives a detail discussion on the assembled code optimization from instruction arrangement, register division, condition selection branch and cycle structure based on the core of ARM9TDMI.
本文基于ARM 9tdmi内核，从指令调整、寄存器分配、条件分支和循环结构等方面对汇编代码的优化方法进行了详细的论述。
The paper introduces main features about the toolbox and give optimization algorithm under constrain condition.
介绍了工具箱的主要特点，并给出了在约束条件下的优化算法。
The sintering experiment is not only base for guiding design and optimization of technics condition but. al- so the important constitute part of sintering investigation.
烧结试验是指导烧结设计、生产工艺条件优化的基础，也是烧结研究的重要组成部分。
The optimization of the best fermentation condition and mixed fermentation.
最佳发酵条件优化及混合发酵。
This paper studies the problem of data association in multisensor multitarget detection under the condition of leakage and describes it as combinatorial optimization in mathematical programming.
研究了漏检情况下多传感器多目标检测中的数据关联问题，并将其描述为数学规划中组合最优化问题。
Vector optimization problems with control parametra are considered under generalized convexity condition.
在广义凸条件下，研究了带控制参量的向量优化问题。
LCL resonant converter behaving as a current source in certain condition and its optimization design method was investigated in this paper.
该文主要研究在一定条件下可实现输出恒流特性的LCL谐振变换器及其优化设计。
The operation condition and technological parameters optimization and adjustment of TC201 air compressor units are introduced. The steam consumption is reduced, the production cost is decreased.
论述了TC 201空气压缩机组性能运行状况和工艺参数优化。使之降低蒸汽消耗，降低生产成本。
So under the condition of flexible foundation, the optimization of cushion thickness of CFG pile composite foundation with caps is of great significance.
因此，对于柔性基础条件下CFG桩桩帽复合地基褥垫层厚度的优化十分有意义。
The optimization results show that the optimization parameters of the displacement restrictor can satisfy restricting condition and the multi-objects optimization can be realized.
计算结果表明，通过优化得到的限位器优化参数能够满足约束条件并实现多目标优化。
In this paper, the blade optimization effect has been investigated by numerical method under the condition of unsteady flow.
本文对叶型优化在非定常流动条件下的效果进行数值研究。
Due to multilayer complex method of the whole optimization procedure at feasible zone, the optimization can meet the condition of constraint.
由于多层复形法全部优化过程都是在可行域内进行，所以得出的优化结果必然满足约束条件。
Due to multilayer complex method of the whole optimization procedure at feasible zone, the optimization can meet the condition of constraint.
由于多层复形法全部优化过程都是在可行域内进行，所以得出的优化结果必然满足约束条件。
应用推荐