Coupled with circuit equations, the opening time of movable contact also can be calculated using iteration with the restriction of contact force.
通过耦合电路方程，并以动触头上的预压力为约束，经迭代运算，确定动触头的打开时间。
Shunt trip Shunt trip is a feature added to a circuit breaker or fusible switch to permit the remote opening of the breaker or switch by an electrical signal.
分励脱扣分励脱扣是线路断路器或可熔电闸的一个特性，可通过远程信号来进行分断或转换。
However, the need for oil flow in hydraulic circuit reverse flows can use hydraulic control, opening a one-way valve, so that the flow of oil can flow in both directions.
但在液压回路中需要油流反向流动时又可利用控制油压，打开单向阀，使油流在两个方向都可流动。
Coupled with circuit equations, the opening time of movable contact also can be obtained using iteration with the restriction of contact force.
加上的电路方程序，可动触点的开口时，也可以得到的使用迭代与接触力的限制。
And it also gives a method of determining rated parameters of circuit breaker opening time by probability distribution.
最后给出了基于概率分布确定断路器额定分闸时间参数的一种方法。
Based on the Artificial Neural Networks, an adjusted scheme of the opening velocity of circuit breaker under the influence of the ambient temperature is put forward.
本文分析了环境温度变化对断路器动作特性的影响，提出了基于神经网络的断路器分闸速度受环境温度影响的调节方案。
With the much higher operating voltages now in use the projected voltage transients or surges due to switching i. e. the opening and closing of circuit breakers, have become the major consideration.
目前随着更高工作电压的使用，由于断路器分闸、合闸操作所引起的电压暂态过程或过电压．已成为主要考虑的方面。
The opening time of movable contact has remarkable effect on the limiting current performance of low voltage molded case circuit breakers.
触头打开时间对于低压塑壳式断路器的限流性能有重要意义。
For LW14 and LW15 SF6 circuit breaker, the reason of reclosing block after opening operation has been analyzed in the paper.
对部分LW14,LW15型SF 6断路器分闸操作后重合闸闭锁的原因进行了分析，提出了改造方案，并在实践中取得了良好效果。
With this method the need of adjustment by grades to opening velocity of high voltage intelligent operation circuit breaker can be met.
该方法可以满足高压智能操作断路器分闸速度分级调节的需要。
The integrated circuit further includes a dielectric material filled into at least a portion of the at least one opening.
集成电路结构还包括一介电材料，填入开口的至少一部分。
With this method the need of adjustment by grades to opening velocity of high voltage intelligent operation circuit...
该方法可以满足高压智能操作断路器分闸速度分级调节的需要。
Conversely, if the pressure in the high pressure part of the circuit drops significantly (to 1-2 bar), the same switch opens in the other direction, again opening the contacts.
反过来说，如果电路中高压端的压强下降幅度过大(到1 -2巴)，开关1会向反方向开启，并再次打开触点。
In the closed position of the circuit-breaker, the opening and closing spring are in charged state. This means the circuit-breaker is in a position to perform O-C-O switching sequences.
在断路器的合闸位置，分闸弹簧和合闸弹簧处于储能状态，此时开关可执行分-合-分操作。
In the closed position of the circuit-breaker, the opening and closing spring are in charged state. This means the circuit-breaker is in a position to perform O-C-O switching sequences.
在断路器的合闸位置，分闸弹簧和合闸弹簧处于储能状态，此时开关可执行分-合-分操作。
应用推荐