Another architecture, that JW sees coming in the next 10 years is the one where "the network connecting enterprise resources to the cloud is a bus on a single chip."
JW认为下一个十年将会兴起的另一个架构是，连接企业资源到云的网络是一个单芯片上的总线。
This paper focuses on performance estimation of the embedded microprocessor based on the on-chip bus, including on-chip bus modeling, high-level simulation environment building and their combination.
本论文的主要工作即着重于系统芯片中片上总线结构的性能评价研究，包括总线结构的建模、系统仿真环境的建立以及性能评价的方法。
The DC servo motors are controlled with motion controller LM629 and motor drive chip LMD18200 based on PC104 bus.
在PC 104总线控制下，应用运动控制芯片LM 629和电动机驱动芯片LMD18200实现了直流伺服电动机的控制。
At last, 1553 bus circuit design has been finished on the basis of studying the basic function and timing of 1553 chip EP-H31580.
最后，在研究EP -H31580 1553总线芯片的基本功能和读写时序的基础上，完成了1553总线模块的硬件设计。
Based on the USB bus interface chip CH375, we design the locomotive signals data recording system, and detail the design of communication interface of CH375 and TMS320F2812.
基于USB总线接口芯片CH375，设计了机车信号记录仪数据记录系统，并详细阐述了CH375与TMS320F 2812之间的接口设计。
IIC bus protocol analysis on the basis of a detailed description in the text adopted by the IIC module DM642 video decoder chip register configuration, calibration process.
在分析IIC总线协议的基础上，文中详细叙述了DM 642通过IIC模块对视频编解码芯片的寄存器进行配置、校验的流程。
This article presents the design of an evaporator system for use with winding plating equipment based on CAN bus, including its hardware structure chip choice and the design of software.
介绍了基于CAN总线的卷绕式镀膜机蒸镀系统的设计方法，阐述了系统设计的硬件及其芯片选用并介绍了软件设计方法。
We complete the design of crossbar switch with 6 ports and 32 bits data bus on one chip of FPGA.
我们在单片FPGA中完成了6个端口、32位数据总线宽度交叉开关的设计。
This paper introduces a design of a CAN bus adapter system based on a new type of USB chip CH372 for the communication of the CAN bus and the computer.
介绍了一种基于新型USB接口芯片CH372的CAN总线网络适配器系统的设计，提出了一种使用USB接口实现CAN总线网络与计算机连接的方案。
Therefore, it will have a bright future to develop VLSI chip based on a PCI bus and related a communication protocol.
因此研究开发基于PCI总线接口和通信协议的超大规模集成电路芯片是具有应用前景和市场价值的。
The research and practice of this dissertation complete the design of a bus bridge module which between the on-chip system bus and the peripheral bus.
本论文的研究与实践工作完成了一个片上系统总线和外设总线之间的总线桥模块设计。
This paper presents an all-purpose design for an intelligent measurement and control unit based on a CAN bus, and describes its hardware structure and chip functions.
文中介绍了一种具有通用性的基于CAN总线的智能测控单元的设计方法，阐述了系统各部分的硬件结构及相应的芯片功能。
The design includes designs of different can controllers for different data nodes, the can module controlled by single chip computer and can bus interface based on DSP TMS320LF2407A, etc.
其设计包括不同数据节点的CAN控制器，及单片机控制的CAN接口模块和基于DSPTMS320 LF 2407a的CAN总线接口等。
The WISHBONE bus is suitable for system communication on chip and configurable.
内部总线采用适合片上系统通信，高可配置性的WISHBONE总线。
The design of SOC usually adopts hierarchical on-chip-bus architecture, different IPs are integrated on different types of buses.
SOC设计通常采用层次化片上总线体系结构，不同的IP集成在不同类型的总线上。
The essay introduces multi-chip calculator communication system based on RS-485 bus, especially MAX-487 chip and the components of the communication system and gives the flow diagram.
介绍了基于RS-485总线的单片机多机通信系统，重点介绍了MAX-487芯片和通信系统的组成，并给出了流程图。
This paper introduces a real-time spaceborne SAR simulator and the hardware design based on the PCI bus and CPLD chip.
论述了星载合成孔径雷达（SAR）回波信号模拟源的一种实时实现方法和基于PCI总线与CPLD的硬件设计。
In the SOC design, the hierarchical on-chip-bus architecture is usually adopted, and different IPs are integrated on different types of buses.
SOC设计通常采用层次化片上总线的体系结构，不同的IP集成在不同类型的总线上。
Bus arbiter was used to arbitrate the embedded bus. A round-robin arbiter was completed in this paper, it can ensure every unit has the equal opportunity to access the on-chip bus.
总线仲裁器用于对嵌入式的总线进行仲裁，文中完成了一个循环优先级仲裁器的设计，它可以保证各功能单元对总线访问的机会均等。
The CLB bus is a kind of on-chip system bus which is usually used to connect IPs with high speed and high data width.
CLB总线是一种片上系统总线，一般用来连接高速度、高数据宽度的IP。
Author research FPGA technique, PCI bus, X86 computer and develop the sub-equipment of communication system based on PCI bus. All of data is transported between FPGA chip and computer by PCI bus.
作者通过对FPGA、PCI总线以及X86构架微型计算机的分析与研究，研制了基于PCI总线的火控系统通信分机，所有数据都通过PCI总线在FPGA与嵌入式计算机之间高速传输。
This topic research based on single bus STC89C52 single-chip microcomputer and the digital temperature sensor DS18B20 multi-spot temperature measuring system.
本课题主要研究基于STC 89c52单片机与单总线DS18B 20数字温度传感器的多点温度测量系统。
The proposal based on USB Host/Slave controller chip CH375A, realized a USB-Host embedded in CAN bus data acquisition system and stored acquisition data of each node in U flash disk under MCU control.
该方案基于USB主/从控制芯片CH375A，在单片机的控制下，实现了CAN总线数据采集系统中嵌入USB主机，从而完成把各节点采集的数据存入U盘，取代了现场数据采集系统必须有一台计算机的模式。
The proposal based on USB Host/Slave controller chip CH375A, realized a USB-Host embedded in CAN bus data acquisition system and stored acquisition data of each node in U flash disk under MCU control.
该方案基于USB主/从控制芯片CH375A，在单片机的控制下，实现了CAN总线数据采集系统中嵌入USB主机，从而完成把各节点采集的数据存入U盘，取代了现场数据采集系统必须有一台计算机的模式。
应用推荐