The probe manager: Software code that defines and provides a set of probe points of the same probe type, such as the system call probe manager.
探测管理器(probemanager)：用来定义和提供一组相同探测类型的探测点的软件代码，比如系统调用探测管理器。
Similar to the Seattle project, this one required new drilling techniques, including the use of probe holes to assess ground conditions ahead of the huge tunnel-boring machines (TBM).
与西雅图的工程相似的是，这里的项目也需要新的钻探技术，包括在上马巨型隧道掘进机(TBM)前使用探孔来评估土质条件。
Map matching is the key problem of probe vehicle technology.
地图匹配问题是浮动车技术中必须解决的关键问题。
Through the use of thousands of probe droids dispatched to comb the galaxy, Vader eventually located the new Rebel base on the ice planet Hoth.
维德派遣了数以千计的侦察机器人到银河系中进行地毯式调查，终于找到了冰雪行星霍斯上的反抗军新基地。
探测扫描的数目。
The therapeutic apparatus is comprised of probe and host.
多极导入治疗仪，由探头、主机二部分组成。
A new design of probe which can prolong device life is presented.
提出了新型探头设计，可以大大延长仪器使用寿命。
The design of probe applied in corrosion measurement was discussed in this paper.
讨论了工业腐蚀测量中测量探头的设计。
A general expression of incident impedance of probe in waveguide is deduced first.
首先推导出波导探针输入阻抗的一般变分表达式。
It is the counterpart of probe and is used to clean up any data structure and state.
它是与探测器相对的功能，用于清除数据结构和状态。
The life of probe is lengthened. The reliability of production apparatus is enhanced.
探头寿命得以延长，生产装置连续运行的可靠性得到增强。
The present paper pinpoints the basic principle of probe-type electromagnetic flowmeters.
本文分析了探头式电磁流量计的基本原理。
The accuracy of near field measurement largely depends on precise location of probe antenna.
近场测量的准确度很大程度上取决于探头的精确定位。
Number of probe scans. A probe scan is used to directly look up rows in an index or base table.
探测扫描的数目。探测扫描用于直接在索引或基表中查找行。
The result shows that the coil type of probe can solve the problem of too long or too short TDR probe;
结果表明，线圈型TDR探针可很好地解决TDR探针在物理长度上的限制；
Each cycle decreases signal by more than 50 %. Recalibration is necessary; lifetime of probe is 6-8 cycles.
每次循环减少信号超过50 %。需要重新校准；探测器的寿命是6 - 8循环。
The temperature dependence of probe was also studied and the rotation relaxation time of probe was calculated.
并研究了温度对探针荧光偏振的影响，计算了探针的旋转松驰时间。
According to the design demands of all parts of probe, several topological structures of suspending parts are presented.
根据测头结构各个部分的设计目标，提出了测头悬挂系统拓扑结构的设计方案。
TPS probe has been used clinically in Europe, but there are no assessments and study reports about this kind of probe in China.
TPS探针在欧洲国家已进入临床应用阶段，但在我国尚未发现有关这方面的评价及应用的研究报告。
To improve the performance of MEMS micro tactile probe, the structure design and parameter optimization of probe are developed.
为了提高MEMS微接触式测头的性能，系统开展了测头的结构设计和参数优化。
Some experimental results of the potential distribution in MM-4 fusion device are presented by measuring the floating potential of probe.
本文描述了用静电探针测量探针悬浮电位的方法，给出MM-4中电位分布的实验结果。结果表明轴向电位分布不对称，径向分布对称；
The power has a good restraining ability form rf interference, and its measurement precisions of probe current and voltage are less than 0. 5%.
电源对射频干扰有很好的抑制能力，电压、电流的检测精度均小于0.5%。
At the same time, the corrections of probe-effect can be easily done and the effect of some key parameters in measurements can be easily discussed.
同时可以很方便地进行探头修正，并讨论天线平面近场测试中各关键参数对测试结果的影响。
This issue is mainly devoted to detect the interference of probe traffic to the links, and how the packet-sent mode impacts the measurement results.
本课题主要就是针对探测流量对链路的干扰以及发包模式对测量结果的影响展开分析和研究。
Test proves that the power supply can achieve demands of probe positioning of SECM, and power supply has high precision, simply circuit, and high reliability.
经实验证明该电源能满足SECM探针驱动中微定位的控制需要，具有精度高、电路简单、可靠性强的特点。
The joint zero position deviations of joint type CMM, which result from assembly technology errors, have an enormous influence on the pose errors of probe end.
关节式坐标测量机的关节零位偏差是由装配工艺误差引起的，对测头末端的空间位姿误差影响极大。
Reviewed are the basic principles and application fields of probe-based imaging microscope, represented by scanning tunneling microscopes for the recent 20 years.
综述了近二十年来以扫描隧道显微镜为代表的、基于探针的成像显微装置基本原理及应用领域。
The Ultrasonic Imaging System is made up of probe excitation circuit, receiving and processing circuit, synchronous control circuit, interface circuit and computer.
超声内窥镜成像系统主要由超声探头激励电路、回波信号接收处理电路、同步控制电路、接口电路以及计算机构成。
On the basis of probe into the architecture of J2ME and the developing process with MIDP, the basic process and method of MIDP application development is summarized.
通过对J 2 ME体系结构及MIDP应用程序开发过程进行深入研究，总结出了MIDP应用程序开发的基本流程和方法。
On the basis of probe into the architecture of J2ME and the developing process with MIDP, the basic process and method of MIDP application development is summarized.
通过对J 2 ME体系结构及MIDP应用程序开发过程进行深入研究，总结出了MIDP应用程序开发的基本流程和方法。
应用推荐