It's important to put a lock washer on that last nut, or it can work loose.
重要的是要在最后一个螺母上安装一个防松垫圈，否则它会逐渐变松。
The two-piece Hard Lock Nut is easy to install, requiring only the use of a wrench.
双件套强力锁紧螺母安装简便，只需要一个扳手就行。
After completing adjustments, tighten the lock nut and replace the fast fill lever cap.
在调节完成后，紧固锁紧螺母，重新安装快速进水手柄帽。
Hold stem (27) on wrench flats and remove nut (51), lock washer (46), diaphragm plate (60) and diaphragm.
在扳手的平面上握住阀杆(27)并拆卸螺母(51)，锁紧垫圈(46)，隔膜板(60)和隔膜。
After the adjustment ended, tighten the lock nut.
调整后，就将锁紧螺母拧紧。
Tang thread fastening and forced lock nut fastening.
即唐氏螺纹紧固及硬锁紧螺母紧固。
The problems in lock nut of roll axis and sleeve of precision rolling mill are analyzed, some measures proposed, good result got.
针对高速线材生产中，精轧机辊轴及隔套锁紧螺母存在的问题进行分析，提出了改进措施，取得了较好效果。
Grasp upper and lower stem lock nut with wrench and loosen.
用扳手抓住上部和下部阀杆锁紧螺母并且松开。
Remove the fast fill lever cap, and loosen the lock nut.
拆卸快速进水手柄帽，松开紧锁螺母。
Small bearings with a bore diameter up to 100 mm can be properly mounted by measuring the lock nut tightening Angle.
孔径最大为100毫米的小型轴承可通过测量锁定螺母的紧固角度正确安装。
The mother of nylon lock, metal lock master, K cap, hex nut, cap-shaped, butterfly hats and all kinds of washers, retaining rings, pins and so on.
尼龙锁紧母、金属锁紧母、K帽、六角螺母、盖帽形、蝶形帽及各式垫圈、挡圈、销类等。
To clean or replace parts; shut off supply, loosen lock-nut and back off adjusting screw.
如果要清洗或更换部件，关闭供应管道，松开锁紧螺母，退出调节螺丝。
The feasibility of repetitive use of Fe-based shape memory alloy lock nut has been studied in order to lower the usage cost.
为了降低铁基形状记忆合金防松螺母的使用成本，探索了该新型螺母重复使用的可行性。
The fracture of the pump shaft is mainly caused by large size non metallic inclusions and point welding between the lock nut and the pump shaft.
结果表明，大尺寸的非金属夹杂和背帽外缘的点焊是引起泵轴过早断裂的主要原因。
The fracture of the pump shaft is mainly caused by large size non metallic inclusions and point welding between the lock nut and the pump shaft.
结果表明，大尺寸的非金属夹杂和背帽外缘的点焊是引起泵轴过早断裂的主要原因。
应用推荐