It refers to maximum pressure that pressure parts can bear up under normal working condition.
在正常工作情况下，受压元件所承受的最高压力。
Derive a way to get the point estimations of parameters under normal working condition stress.
给出了求正常工作应力下参数点估计的方法。
Under the normal working condition, the temperature rise of Ji'nan luminous words should be very low.
济南发光字在正常作业状态下，其温升应很低。
The failure modes of the combination valve hot forging die in normal working condition are wear, collapse or cold hot fatigue crack.
气门锻模正常失效方式为磨损、压塌和冷热疲劳裂纹。
Low maintenance cost. Under normal working condition, this equipment is generally maintained semiyearly after the installation and debugging.
维护保养成本低。设备安装调试完毕后，在正常工作情况下，半年只需维护一次。
The system normal working condition was recovered by reducing production output and carrying out corresponding operations.
通过减量生产，并采取相应操作，系统工况恢复正常。
The main controller passed the electro-magnetic compatibility tests, high and low temperature tests and vibration tests and presented a normal working condition.
该主控制器通过电磁兼容测试、高低温及振动测试后，系统工作正常。
Using computer simulation technology, this thesis is aimed to build a model of KM385BZL crankshaft and to analyze its dynamic characteristic in normal working condition.
本文旨在利用计算机的仿真技术建立KM385BZL曲轴模型，分析该型曲轴正常工况下的动态特性。
It was very complicated when taking the traditional equivalent section method to calculate the section stress of steel concrete structural unit under its normal working condition.
对于钢筋混凝土构件在正常使用状态下的截面应力计算，用传统的“等效截面法”计算十分复杂。
This paper, in conjunction with on-site actuality, puts forward rational job treatment and remedial measures with fairly good results to ensure normal working condition and safety.
本文结合现场实际，提出了合理的施工处理措施，整治效果良好，保证了正常施工和安全。
Shift, the direction can not be "killed", especially when turning in place, it is necessary to leave some margin to ensure that the hydraulic steering system is in normal working condition.
转向时，不可将方向“打死”，特别是在原地转向时，要留有一定的余量，保证液压转向系统处于正常工作状态。
Shift, the direction can not be "killed", especially when turning in place, it is necessary to leave some margin to ensure that the hydraulic steering system is in normal working condition.
转向时，不可将方向“打死”，特别是在原地转向时，要留有一定的余量，保证液压转向系统处于正常工作状态。
应用推荐