During normal construction process, the friction force between shield and soil exhibited greater influence on surface deformation compared with bulkhead additive thrust.
在正常施工时,盾壳与土体之间的摩擦力对地面变形的影响远大于正面附加推力。
That the temperature of thrust bearing pad exceeds the alarm temperature designed for unit No. 1 at Yele Hydropower Plant impedes the normal operation of the unit.
冶勒水电站1号机组在试运行过程中推力轴承瓦温超过设计的报警温度,无法继续运行。
The ratio of poloidal to toroidal component of mantle convection determined the proportion of seismic energy released in the thrust, normal, or strike-slip earthquakes.
地幔对流的垂直运动与水平运动分量的比率,决定了逆冲、引张与走滑型强震的能量释放份额。
Focal mechanisms demonstrate that most are of thrust fault and next the normal.
几百次单个地震的震源机制解显示出以逆断层和正断层机制为主。
A novel rapid method to design optimal-fuel interplanetary trajectory for low-thrust propulsion is presented based on normal trajectory approach.
针对星际探测任务中燃料最省小推力转移轨道问题,提出一种基于标称轨道的快速设计方法。
The MCT1 was originally a south-vergent ductile thrust, which was later transformed into a normal fault after it underwent NNE-trending folding.
MCT1原为向南逆冲的韧性断层,后遭受北北东向褶皱作用而转变为正断层。
Compared to the testing system of conventional rotatory motor, the one of 3-phase linear induction motor (LIM) is quite different with the measuring of thrust and normal force.
相比普通旋转电机,三相直线异步电机静态测试时推力和法向力的测定比较特殊。
The tear fault intersected with low angle normal fault or thrust fault can form some traps, e. g. trap-door structure trap.
撕裂断层与低角度正断层或逆冲断层相交时常形成有利圈闭,如活板构造等。
Two kinds of the normal force of the linear servo motor are analyzed by using finite element analysis. The relations between thrust, normal force and air gap length are analyzed.
采用有限元分析的方法对直线伺服电机的两种法向力进行分析,分析了推力、法向力与气隙长度的关系。
The structural styles of the basins in early stage are all half-graben depression and in late stage are total-reverse thrust nappe and semi-reverse normal- or abnormal-reverse structures.
盆地早期的构造样式均为半地堑式箕状凹陷,晚期均发生方式不同的的构造反转,形成全反转的逆冲推覆和半反转的正或逆反转构造。
A device on the engine for blocking the normal airflow during thrust reverser operation.
发动机上的一个装置。在反推工作时用于阻挡正常的气流。
The system implements remote control and improves calibration accuracy, efficiency and security. The result of thrust calibration in normal temperature attains 0.05%.
该系统实现推力校准的远距离控制,提高校准精度、效率和安全性,常温校准结果可达到0.05%。
There is a normal deposition sequence stratigraphy beneath the lower wall of over-thrust fault, such as Jurassic, Triassic, Permian-Carboniferous, Cambrian-Ordovician system.
在逆冲断裂的下盘,是一套正常沉积层序的地层,分别为侏罗系、三叠系、石炭—二叠系、寒武—奥陶系等地层。
There is a normal deposition sequence stratigraphy beneath the lower wall of over-thrust fault, such as Jurassic, Triassic, Permian-Carboniferous, Cambrian-Ordovician system.
在逆冲断裂的下盘,是一套正常沉积层序的地层,分别为侏罗系、三叠系、石炭—二叠系、寒武—奥陶系等地层。
应用推荐