You can kill the connection either by using the kill command with Control-C (if you've started up in non-daemon mode), but the best method is to use the gvpectrl command shown in Listing 11.
可以使用 kill命令和Control-C 终止连接（如果以非守护进程模式启动的话），但最好的方法是使用gvpectrl 命令，如 清单11 所示。
The control system utilizes a sliding mode observer for the generation of all controller feedback information by means of non-speed information, such as voltage, current and parameters of motor.
利用非速度信息，如：电机的电压、电流及电机本身参数，通过滑模观测器产生控制器所需的速度反馈信息。
Meanwhile, the set condition that pedestrian crossing transform from non-signal control mode to signal control mode was analyzed by using probability theory and gap acceptance theory.
基于概率论方法和可穿插间隙理论，分析了人行横道由无信号控制方式过渡至信号控制方式的设置条件；
In such situations, you will probably get better results if you use the plain TTL or non-TTL Auto mode. In some cases, you may need to take full control and switch to Manual mode.
在上述情形下，可能使用TTL或非ttl自动模式更好些，有时甚至需要完全使用人工控制模式。
This paper present non-modularized structure of tight coupling mode workflow control in this paper.
提出了非模板化的紧藕合式工作流控制方式。
An adaptive neural sliding mode control strategy with the self-tuning of robust item coefficients is proposed for the trajectory tracking of non-holonomic wheeled mobile robots.
针对非完整移动机器人的轨迹跟踪控制问题，提出了一种鲁棒项系数自调整的神经网络滑模自适应控制策略。
An adaptive neural sliding mode control strategy with the self-tuning of robust item coefficients is proposed for the trajectory tracking of non-holonomic wheeled mobile robots.
针对非完整移动机器人的轨迹跟踪控制问题，提出了一种鲁棒项系数自调整的神经网络滑模自适应控制策略。
应用推荐