Simulation results for non-isothermal flow pass plate have been shown.
并给出了平板非等温流体绕流流动现象的模拟结果；
Numerical simulation of non-isothermal flow of fiber reinforced polymeric melt;
纤维增强聚合物熔体的非等温流动数值模拟；
The theoretical dynamic simulation models for stationary flow and transient flow under the isothermal and non-isothermal condition are set up based on the three conservation equations.
以流体力学三大守恒方程为基础，建立了等温和非等温条件下的燃气管网稳态和动态仿真理论模型。
This thesis concentrates on simulation of Non-Newtonian isothermal flow in kneading block in closely intermeshing co-rotating twin screw extruders.
本文主要就全啮合同向双螺杆挤出机捏合块流道中熔体全充满区的流动进行了全三维非牛顿等温模拟。
The modeling for three-dimensional incompressible viscous non-isothermal steady flow was presented by using penalty finite element method.
针对幂律型流体，建立了稳态三维粘性不可压缩流体非等温流动的有限元模型。
Particularly, large discrepancy results when solving non-isothermal indoor air flow with RANS.
特别是对于非等温流动，用RANS法预测高大空间气流组织误差较大。
The isothermal and Newtonian model for single layer melt flow was analyzed, as well as the non-isothermal and non-Newtonian model.
对于单层模拟，分别进行了等温牛顿模型和非等温非牛顿模型的分析。
The flow pattern of molten steel in tundish of the 6-strand bloom caster at PZH steel were investigated by physical simulation with isothermal and non-isothermal model.
针对攀钢六流大方坯连铸中间包，采用等温和非等温物理模拟的研究方法，研究了钢水在中间包内的流动规律。
The non-isothermal phenomenon may bring about significant effect on the fluid flow and heat transfer.
液 的非等温现象对中间包内流体流动和传热有着重要的影响。
Axial circle flow was introduced. The isothermal flow analysis of non-Newtonian fluid in axial circle region of a non-intermeshing counter-rotating twin-screw extruder was concerned.
引入了轴向循环流动的概念，且利用ANSYS有限元分析软件对非啮合双螺杆挤出机轴向循环流道中的非牛顿流体等温流动进行了三维模拟分析。
Axial circle flow was introduced. The isothermal flow analysis of non-Newtonian fluid in axial circle region of a non-intermeshing counter-rotating twin-screw extruder was concerned.
引入了轴向循环流动的概念，且利用ANSYS有限元分析软件对非啮合双螺杆挤出机轴向循环流道中的非牛顿流体等温流动进行了三维模拟分析。
应用推荐