Based on analyzing the intersection curve between the rolled-piece and roll, the method of determining the nip point is put forward.
基于对轧件与轧辊截交线的分析，提出了在二维直角坐标系中确定轧件咬入接触点的方法。
The die lips are V-contoured to minimize the air gap between the die and the roll nip whenever necessary.
模具口是V型的，为了随时减少模具和辊轴间的空气间隙。
The groove depth of the warping roll is as long as a half of the cord diameter. The nip between the pressure roll and No.
整经辊的沟槽深度等于帘线直径，压力辊的沟槽深度为帘线直径的一半。
The loading pressure is calculated separately for each rider roll depending on the required nip pressure and respective sheet length. The related diameter–dependent set curve is stored in TRUTEC .
加载压力被单独为各自的骑辊加压，根据压区压力要求和各自的复卷长度，相关的纸卷直径，根据在TRUTEC设定的曲线。
The loading pressure is calculated separately for each rider roll depending on the required nip pressure and respective sheet length. The related diameter–dependent set curve is stored in TRUTEC .
加载压力被单独为各自的骑辊加压，根据压区压力要求和各自的复卷长度，相关的纸卷直径，根据在TRUTEC设定的曲线。
应用推荐