There are two sorts of tenon sleeve: 925 silver or Ni alloy.
音色独特，插口有两种选择：镍合金管或者925银管，避免氧化。
The Wiedemann effect of Fe-Ni alloy wires were measured by a self-made apparatus.
使用自制的威德曼效应测量仪测量铁镍合金丝的威德曼效应。
The property of the coating is identical with electroplating Zn-Ni alloy coating in ammoniate.
研制成功一种钾盐无援电镀锌-镍合金新工艺。
Then, black Sn-Ni alloy plating and ti carbide ion plating, quite well received currently, are discussed.
其次是黑色镀层，探讨了目前较受欢迎的电镀黑色锡镍合金及离子镀碳化钛。
In this article, the effects of rare earth on Zn-Ni alloy electroplating from sulfate bath have been studied.
研究了稀土在硫酸盐体系电镀锌镍合金中的作用。
The technology of low hydrogen embrittlement Zn-Ni alloy electroplating on aeronautic high strength steel was studied.
对航空高强钢低氢脆电镀锌-镍合金工艺进行研究。
In this paper, the corrosion behavior of RE-Ni-Cu and Cu-Ni alloy cast iron in the caustic lye of soda was researched.
本文对稀土镍铜合金铸铁和铜镍合金铸铁在烧碱液中的腐蚀行为进行了系统的研究。
By using this new process, Zn-Ni and Zn-Al-Ni alloy coatings with different proportions on steel substrate are obtained.
利用该工艺在钢基表面上得到了不同配比的锌镍以及锌铝镍合金镀层。
The practicability on Ti-Ni alloy manufactured by direct electrochemical reduction of TiO2 and NiO oxides was investigated.
研究了利用熔盐电解法从金属氧化物中直接电解制备钛镍合金的可行性。
This text simply introduce the technology for Sn-Ce-Ni alloy electroplating. Plating solution is stable. Coat quality is good.
本文简要介绍锡铈镍合金电镀工艺。本工艺镀液稳定，电镀层质量好。
The analysis of Auger spectra of Cu, Ni and Cu-Ni alloy also shows that the "Rigid Band Model" is not suitable for Cu-Ni system.
从铜-镍合金的俄歇谱分析可知，合金能带的刚性能带理论并不适合本研究系统。
This paper presented putting use of the wasted mud residue of plating Zn-Ni alloy to reclaiming bath by chemical deposition method.
本文叙述了化学沉淀法处理电镀锌镍合金废水所得到的污泥回槽利用问题。
Counter-flow spray technique for the treatment of the rinsing water containing pyrophosphates in Cu- Sn-Ni alloy plating is described.
电镀焦磷酸盐铜锡镍废水由“常流水”清洗方式改为反喷淋清洗方式。
Properties of the Zn-Ni alloy deposit were determined with the methods of X-ray diffraction analysis, microhardness and salt -spray test.
采用X—射线衍射分析法、显微硬度测试法和盐雾试验法来检测镀层性能。
The Fe-Cr-Ni alloy lined composite pipes have been produced by the SHS centrifugal process and the corrosion resistance of the Fe-Cr-Ni alloy have been studied.
利用SHS—离心法制备铁-铬-镍合金内衬复合钢管，系统研究内衬层的耐蚀性能。
A new kind of boron nitride based shell mold used for investment casting titanium alloys was fabricated and the reaction between it and Ti-Ni alloy was investigated.
研究了一种新型钛合金精密铸造用型壳——氮化硼基复合型壳及其与钛镍合金的界面反应和反应层的形成机制。
Based on Zinc and Zn-Al alloy mechanical plating, a new Zn-Ni alloy mechanical plating process is developed through adjusting type and dosage of activators and promoters.
在机械镀锌、锌铝工艺的基础上，通过调整活化剂和促进剂的种类及用量，研制开发了机械镀锌镍合金工艺。
The effects of pulse and periodic current parameters on the composition of Pd -ni alloy deposit and on the current efficiency of the electrodeposition process have been studied.
本文考察和研究了脉冲电镀及周期换向电镀法中各项脉冲参数对钯-镍合金的镀层成份、电流效率的影响。
The influence of an organic complexing agent AD on electrodeposition of Mg-Ni alloy in organic bath on Cu electrode was studied by using cyclic voltammetry and AC impedance methods.
通过循环伏安法、交流阻抗法研究了一种有机络合剂对有机镀液中镁-镍合金在铜上共沉积的影响。
The effect of bath composition, operating conditions and additives on Sn content of electrodeposits during the process of Sn-Ni alloy electroplating in alkaline baths had been studied.
在研究碱性锡镍合金的电沉积过程中，讨论了镀液中各成分的含量、电镀工艺条件的改变及添加剂对锡镍合金镀层成分和外观的影响规律。
The results show that this complexing agent is useful for electrodeposition of Mg-Ni alloy. Proper addition of AD agent can significantly increase the maximum specific discharge capacity …
结果表明，络合剂对电沉积是有利的，适量络合剂的加入能显著提高以镁-镍合金镀层为电极的最高放电比容量。
Objective: To evaluate the effect of Ni-Ti shape memory alloy stand for trachea stenosis.
目的：探讨镍钛记忆合金支架在治疗喉气管外伤所致的气管缺损或狭窄中的疗效。
High energy density electron beam is employed in surface rapid solidification on Ni plated ti alloy.
采用高能量密度电子束进行了钛镀镍合金表面熔凝处理的研究。
After proper filtration and precipitation, the loose black layer had little effect on the electroforming process of the Ni-Mn alloy.
采取正确的过滤和沉淀措施后阳极黑色附着层对镍锰合金电铸过程不会产生明显的影响。
Electroless Ni-P alloy deposits have been widely adopted in industries for their excellent properties.
由于具有优良的性能，化学镀镍磷合金在工业上得到了广泛应用。
Objective: This study is to determine the effect of different surface anodizing and degassing-preoxidation on bonding strength of porcelain to Ni-Cr alloy.
目的：研究非贵金属合金在上瓷前经过不同的阳极钝化条件处理及除气、预氧化对金瓷结合强度的影响。
The results show that the fatigue life of electroless Ni-P alloy specimen could be dropped.
结果表明，化学镀镍磷合金之后，镀态试样的疲劳寿命明显下降；
The method was developed for the matrix determination and the component analysis by the character line in Ni-based alloy based on digital simulation.
在镍基合金可见光谱计算机模拟基础上，研究利用镍元素及成分元素特征谱线进行基体鉴别和成分元素分析的方法。
C1023 is a cast Ni-base alloy used for turbine nozzles.
C1023是一种作导向器材料的镍基铸造合金。
C1023 is a cast Ni-base alloy used for turbine nozzles.
C1023是一种作导向器材料的镍基铸造合金。
应用推荐