The corona voice strengths and levels of radio interference produced by positive polarity wire have little changes, and those produced by negative polarity wire increase with temperature.
正极性导线电晕声音和无线电干扰变化都不大；负极性导线电晕声音和无线电干扰都增大。
The utility model relates to a miniaturized positive ion electrostatic field formed by an electric traveling band type flexible negative electrode and an auxiliary thin wire type positive electrode.
本实用新型是由电动走带式柔性负电极辅以细线状正电极形成一个正离子小型化静电场。
Weld penetration and wire melting speed of AC PMIG welding not only have relationship with welding current but also with electrode negative ratio.
交流脉冲MIG焊其焊缝熔深及焊丝熔化速度不仅与焊接电流有关，而且与负极性比率有关。
Experimental results prove the proposed control method can compensate the harmonic, negative sequence and zero sequence current components in the three phase four wire.
实验结果表明，该装置可对三相四线制系统中的谐波、负序、零序等电流分量进行补偿。
With increasing the embedded depth of iron wire, the negative shift value of corrosion potential, chlorine ion concentration and corrosion rates reduced, but polarization resistance increased.
随铁丝埋入深度增加，电位负移量、氯离子浓度和腐蚀速度都减小、极化电阻增加。
The control to welding procedure is realized by a control circuit, and wire feed rate is regulated and controlled by speed governing circuit with the armature voltage negative feedback.
由控制电路实现焊接程序的控制，带电枢电压负反馈的调速电路控制和调节送丝速度。
The electric current in a wire is usually said to flow from the positive to the negative electrodes of the battery, which is opposite to the way in which the electrons move.
电子中的电流通常是从电池的正极流向负极，这同电子的移动方向刚好相反。
To analyze the formation of surface discharge on a dielectric plate under positive nanosecond impulse voltage in air, a wire to plane electrode system with a barrier of negative film was used.
采用感光胶片作为阻挡介质的针-板放电系统，解析空气中固体电介质上纳秒正脉冲表面放电的形成过程。
When electrode negative ratio is zero, which is using MIG welding with DC ami welding wire being positive polarity, weld penetration is maximum , wire melting speed and deposition rate are minimum;
当负极性比率等于零即直流且焊丝为正极性的MIG焊时，其焊缝熔深最大，焊丝熔化系数最小，熔敷速度最小；
When electrode negative ratio is zero, which is using MIG welding with DC ami welding wire being positive polarity, weld penetration is maximum , wire melting speed and deposition rate are minimum;
当负极性比率等于零即直流且焊丝为正极性的MIG焊时，其焊缝熔深最大，焊丝熔化系数最小，熔敷速度最小；
应用推荐