Storage vendors will present MPIO disk differently.
存储供应商将会区别地呈现MPIO磁盘。
Best practices would not recommend MPIO and mirroring on the same system.
最佳实践不建议在同一系统上同时配置MPIO和镜像。
Ensure that MPIO for the disks is configured and functioning appropriately.
确认已经适当地配置了磁盘的MPIO。
Please keep this is in mind when dealing with your storage devices and MPIO code.
在处理存储设备和MPIO代码时,要谨记这一点。
Both PCMs allow for any MPIO device to be used as a paging device and a dump device.
两个PCM都支持任何MPIO设备作为分页设备和转储设备使用。
When connecting to an IBM DS8100 storage device, the supported MPIO software is SDDPCM v2.2.0.
在连接ibmDS8100存储设备时,支持的MPIO软件是SDDPCMv2.2.0。
All the prerequisites and restrictions that are listed in the previous sections are applicable for the MPIO scenario.
前面列出的所有前提条件和限制也适用于MPIO场景。
Rather than mix two vendors' MPIO code on the same VIOS, it may be simpler to manage if each storage type has its own VIOS.
与在相同的VIOS混合两个供应商的MPIO代码相比,如果每种存储器具有其自己的 VIOS将更容易管理。
For example, Figure 3 highlights a MPIO-based configuration for virtual disks (hdisk0 and hdisk1) on the aix partition (aix_lpar1).
例如,图3突出显示了aix分区(aix_lpar1)上虚拟磁盘(hdisk0和hdisk1)的MPIO配置。
The AIX and VIOS default MPIO (AIXPCM) is provided as an integrated part of the base VIOS POWERVM firmware and AIX operating system product distribution.
AIX和vios默认mpio (AIXPCM)只作为基础VIOSPOWERVM固件和AIX操作系统产品的一个集成部分提供。
Redundant HBAs on each DB2 member and the use of multipath software, such as IBM AIX MPIO, or device drivers that support multipath access to LUNS is recommended.
建议在每个DB2成员上使用冗余HBAs,使用多路径软件(比如IBMAIX MPIO),或者支持LUNS 多路径访问的设备驱动器。
If you are migrating from IBM to IBM storage, then it is likely that you will simply need to update the MPIO code, FC adapter firmware and supporting device drivers.
如果您是从ibm存储迁移到IBM存储,那么您可能只需要更新此MPIO代码、FC适配器固件以及设备驱动器。
If you are migrating from IBM to IBM storage, then it is likely that you will simply need to update the MPIO code, FC adapter firmware and supporting device drivers.
如果您是从ibm存储迁移到IBM存储,那么您可能只需要更新此MPIO代码、FC适配器固件以及设备驱动器。
应用推荐