锭模材料？
A new water soluble core-mould material was prepared by blending of phosphate ester starch and different fillings.
将磷酸酯淀粉与刚性填料，通过共混制备了新型的水溶性芯模材料。
This paper introduces the requirement of mould material and technology of circuit breaker handle, the location of runner and the determination of injection mould structure.
文中叙述断路器手柄塑件材料和工艺的要求、浇口位置的分析及合理确定注塑模具结构。
The results showed that the content of filling was better to be 10% and the water soluble core-mould material had high strength, good glassy surface, good water-solubility, and so on.
实验结果表明，在磷酸酯淀粉中加入质量分数10%的刚性填料所制得的水溶性芯模材料，具有强度高、表面光洁、水溶性好等特点。
The results showed that the content of filling was better to be 10% and the water soluble core-mould material had high strength, good glassy surface, good water-solubility, and so on.
实验结果表明，在磷酸酯淀粉中加入质量分数10%的刚性填料所制得的水溶性芯模材料，具有强度高、表面光洁、水溶性好等特点。
应用推荐