The characteristics of fluid flow in the mould of two ports SEN and four ports SEN have been compared and the influences of SEN on the level fluctuation are investigated by water modeling experiment.
比较研究了薄板坯连铸用二孔型水口和四孔型水口流场特征，水模试验结果表明，采用两种水口的薄板坯结晶器流场均存在非稳定性现象。
Fluid flow in the mould must be optimized in order to improve the internal and surface quality of the slabs while increasing the casting speed.
在拉速提高的条件下，必须优化结晶器内流场以适应稳定生产的需要，防止气孔、拉漏等铸坯缺陷的产生。
A three dimensional incompressible gas-liquid two-phase flow model was proposed to accurately simulate the fluid flow of casting's mould filling process.
为了更精确地模拟铸造充型过程的流动行为，建立了充型过程的三维不可压缩气。液两相流动模型。
The fluid flow phenomena happened in the mould of continuous casting of aluminium alloy was studied by digital particle image velocimetry(DPIV) technology.
利用先进的数字粒子图像测速技术（DPIV）对铝合金板坯连铸过程中结晶器内的流场进行研究。
The fluid flow phenomena happened in the mould of continuous casting of aluminium alloy was studied by digital particle image velocimetry(DPIV) technology.
利用先进的数字粒子图像测速技术（DPIV）对铝合金板坯连铸过程中结晶器内的流场进行研究。
应用推荐