This paper introduced several structures of single punching dies of rotor shield plank of motor, then compared them and drew a conclusion.
介绍了电机转子端板单槽冲模的几种结构形式，对这几种结构进行了比较，并给出结论。
This paper introduces a class H insulation system of shield motor. The new insulation system is better than of silicon in irradiation resistance, breakdown strength, mechanical properties and so on.
本文介绍了一种新型H级屏蔽电动机的绝缘体系，在耐辐照方面它大大优于有机硅绝缘体系。
Pump motor in the loss of shielding, the stator shield sets great loss, in some cases, iron loss of 2 to 3 times the shield repair kits after the loss should be maintained at the same level.
在屏蔽泵电机的损耗中，定子屏蔽套损耗很大，有时达到铁损耗的2~3倍，修复后的屏蔽套损耗应维持在原有水平。
It is comprised of multiple stage centrifugal pump, double stage gas separator, protector, submersible motor, guard shield and setting gas separator.
它主要由多级离心泵、双级分离器、保护器、潜油电机、护罩、沉降分离器组成。
Stamping process plan of end shield for special motor was introduced.
阐述特种电机端罩冲压工艺方案。
According to the thermal shielding model of solid rocket motor, an approach of ablation heat shield design of end-burning grain with embedded wire was put forward in this paper.
根据固体火箭发动机绝热防护模型，提出了一种嵌金属丝端燃装药绝热层设计方法。
When normally driving, the driver can reversely rotate the motor rotating shaft to drive the wind shield to retract into the interlayer of the roof.
正常驾驶时，把电机转轴反转，带动挡风板缩入车顶夹层内便可。
Fee: 80rmb per person, including a motor-sensor shield board.
费用：每人80元，包含一块电机和传感器控制电路板。
Fee: 80rmb per person, including a motor-sensor shield board.
费用：每人80元，包含一块电机和传感器控制电路板。
应用推荐