In conventional motion control systems, photoelectric encoders or rotary transformers are used for this purpose.
在传统的运动控制系统中，通常采用光电编码器或旋转变压器来检测转子的位置和速度。
In conventional motion control systems, optical encoders or electromagnetic resolvers are used for this purpose.
在传统的运动控制系统中，通常采用光电编码器或旋转变压器来检测转子的位置和速度。
In this paper the operational principle of typical motion control systems composed of common purpose motion controllers is analyzed.
分析采用运动控制器的典型运动控制系统的工作过程。
Because of the high calculation complexity of motion control, computers and control-cards have been used in most traditional motion control systems.
由于对运动的控制计算量相当之大，因此传统的控制系统大都采用计算机与控制板卡实现。
In order to improve the performance of networked multi-axis motion control systems, the clock synchronization method of motion control networks was studied.
为了改进网络化多轴同步控制系统的性能，研究了运动控制网络的时钟同步方法。
Finally, we analyse and design the software of digital motion control systems based on USB, including the firmware of USB device, the drivers of USB device.
最后设计开发了采用USB技术的数字运动控制系统的软件，包括USB设备固件程序、U SB设备驱动程序。
Therefore, in this paper, a special protocol is defined for the motion control systems, and a standard communication format and a communication bandwidth distribution method are designed.
本文针对运动控制系统定义了应用层的协议，设计了标准的通信格式以及通信带宽分配方式。
In this paper we design a fuzzy self-tuning controller which can be used in motion control of oceanic dynamic positioning systems.
本文设计了一个用于海洋动力定位系统运动控制的模糊自适应控制器。
Besides, by integrating with surgical robots, virtual surgery simulation could also afford accurate positioning information to master-and-slave motion control of the robot systems.
通过与手术机器人控制系统的集成，虚拟手术仿真还可以为机器人系统的主从运动控制提供精确的定位信息。
Primarily designed for use with festoon systems for the conveyance of electrical power and control to cranes, hoists, or any equipment which travels with a lateral traversing motion.
最初设计用于拖令系统的输电，信号传输，从而控制起重机，提升机或任何侧横向运动的设备。
Iterative learning control is an effective technique for improving the tracking performance of systems that execute the same trajectory motion again and again.
对于完成重复轨迹跟踪任务的系统，迭代学习控制是一种能有效地改进其跟踪性能的技术。
Iterative learning control is an effective technique for improving the tracking performance of systems that execute the same trajectory motion again and again.
对于完成重复轨迹跟踪任务的系统，迭代学习控制是一种能有效地改进其跟踪性能的技术。
应用推荐