The design principle of mold drying control, system structure and the program control were expounded.
阐述了消失模烘干的方案设计、系统构成和程序控制原理。
Design calculation of chamber sand-mold drying oven is programmed by comuter instead of using diagram method.
本文采用电子计算机进行砂型室式干燥炉的设计计算。
On the basis of analyzing the drying process of the foam pattern, the mold drying control system based on PLC was designed.
在分析研究模样干燥过程的基础上，设计了基于PLC的消失模烘干控制系统。
The forming technology was analyzed, including drying of PET resin and the temperature control of mold work section. The construction of a hot runner mold and its mechanism were described.
分析了PET瓶坯的成型工艺，包括PET树脂的干燥、模具工作部分的温度控制等，阐述了热流道注塑模的结构及工作原理。
Using mold prepared by compound method, on the basis of different drying time curve attained by changing environmental humidity and temperature, the optimized processing parameters were determined.
采用复合法制备型壳，在制备过程中，改变不同的环境湿度和温度而得到型壳的不同干燥时间曲线，确定工艺参数优化值。
In high humidity circumstance, it was cautioned that shell mold should be dried before next coating layer should be brushed and drying time should be extended before shell mold dewaxed.
在高湿度环境下，应注意待型壳干燥后再涂挂下一层涂料，型壳脱蜡前须延长干燥时间。
After several more drying steps, the paper is carefully lifted back from the mold. It is now strong enough to be touched.
再经过几次干燥过程之后，将纸张小心地从模具中取出，此时的纸张已经很强壮，可以触摸了。
The delicate, bright and clean lipstick was finally made through pouring mold to shape and drying by soft fire.
浇模成型，再经过文火煨烘，制成表面光洁、细致的唇膏。
Drying the materials in a restricting mold diminished the horizontal shrinkage, and the vertical shrinkage was higher than that in the mold-less drying.
材料置于模具中进行干燥可以消除水平方向的收缩，但高度方向的收缩率大于无模具干燥下的收缩率。
After several more drying steps, the paper is carefully lifted back from the mold.
在若干风干工序之后，要小心翼翼地把纸张从模子里取出。
After several more drying steps, the paper is carefully lifted back from the mold.
在若干风干工序之后，要小心翼翼地把纸张从模子里取出。
应用推荐