• Sensor module is composed of sensor circuit, modulation circuit and analog signal switch.

    传感模块由传感器电路、调制电路和模拟信号开关组成。

    youdao

  • PSD nonlinearity modulation circuit was designed to achieve low temperature drift and high precision.

    设计出一种低温漂高精度的PSD非线性硬件调制电路。

    youdao

  • The laser source was modulated by the modulation circuit, so that the fluorescence signal was modulated.

    信号调制电路通过对传感器系统的激光光源进行调制来调制荧光信号。

    youdao

  • Because of built-in PWM circuit (pulse width modulation circuit), dimming range is wider than earlier type products.

    因使用PWM(脉冲宽度调制)电路,产品具有较宽的调光范围。

    youdao

  • Oscillation modulation circuit which can provide the signal carrier with stable frequency is the key point in the subject.

    本课题重点在于设计能给发射机电路提供稳定频率的振荡调制电路。

    youdao

  • The hardware of this system includes pressure transducer board array, signal modulation circuit, signal capture board and PC.

    系统硬件包括压力传感器平板阵、信号调理电路、信号采集板以及计算机系统。

    youdao

  • The traditional class D amplifier is composed of three parts: modulation circuit, driving circuit and power amplification circuit.

    传统的D类放大器一般由三部分组成,即调制电路、驱动电路和功率输出电路。

    youdao

  • Have designed the frequency modulation circuit in the CIC-CPPFC electronic ballast circuit, which would decrease the crest factor of circuit.

    设计了用于电流输入连续型电荷泵功率因数校正电子镇流器的调频电路,以减小电路的峰值系数。

    youdao

  • General by the command transmitter key, instruction encoding circuit, modulation circuit, driver circuit, firing circuit, such as a few parts.

    发射器一般由指令键、指令编码电路、调制电路、驱动电路、发射电路等几部分组成。

    youdao

  • The chopping modulation circuit model of the pyroelectric infrared camera is introduced. The circuit design and analysis for the circuit model were made.

    本文提出了热释电红外摄像机斩波调制的电路模型,并对此电路模型进行了具体的电路设计和分析。

    youdao

  • The emitting coil and capacitance are connected in parallel and form a resonant amplitude-modulation circuit, which converts the impedance into output voltage.

    利用发射线圈与电容并联的谐振调幅电路,将线圈阻抗变化转换成电压的输出。

    youdao

  • Then, the paper elaborates the design principles of RF front-end circuit, including high efficient rectifier, modulation circuit, demodulation circuit and ESD protection.

    然后本文详细阐述了射频前端电路设计原理及过程,包括高效倍压整流电路、调制电路、解调电路和ESD保护电路。

    youdao

  • Capacitive pressure difference sensor is fixed in the center of the tube and connected with the pulse width modulation circuit so that capacitive flow transducer is made up.

    把电容式差压传感器固定在管道中央,并配接脉冲调宽电路,即构成电容式流速变送器。

    youdao

  • In order to improve the frequency stability of the frequency modulation circuit and the crystal oscillator, using the temperature compensation circuit is extremely effective method.

    为了提高调频电路和晶体振荡器的频率稳定度,采用温度补偿电路是一种极其有效的方法。

    youdao

  • The circuit of Photoelectricity Weak Signal Detection, preamplifier circuit, difference circuit, modulation circuit, optical source thermal control and current drive circuit etc. are designed.

    设计实现了基于差分后谐波检测的微弱信号处理电路、前置放大电路、差分电路、调制电路和光源温度控制电路及电流驱动电路等。

    youdao

  • The circuit of Photoelectricity Weak Signal Detection, preamplifier circuit, difference circuit, modulation circuit, optical source thermal control and current drive circuit etc. are designed.

    设计实现了基于差分后谐波检测的微弱信号处理电路、前置放大电路、差分电路、调制电路和光源温度控制电路及电流驱动电路等。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定